Heelo. I havent used my camera for a long time, now whenever i open the cam this message appears on the screen : "Push the reset switch". i did it so, but the message reappears in short time. What could be the cause? Could you help, pls?
SOURCE: help me pls
Hi
The reset button is right next to to eject button on the left hand side.
It is black and so its the writing so not easy to see.
Regards Mario
SOURCE: error message "push the reset switch"
Set the
cam. to whatever you're going to do, record or play. Check the DV tape
record/play tab is in the correct position. Turn cam on. open
clamshell; insert tape correctly and always push PUSH to close and start the loading sequence.
A couple of things to avoid. When playing a tape, never press tape
rewind without pressing stop tape first, the cam. will likely jam.
Reported here early last year.
Make sure the cam. strap is pulled clear of the clamshell when opening
it. It needs to open fully to start the transport opening sequence.
Don't repeatedly load and unload the tape without running it
SOURCE: Panasonic Nv-EX3 - Error F02
Hi
I have just had the same problem and I have just charged my battery, taken out the tape, switched the camera off and when switched back on and re-entered the tape everything is working. Hope this helps.
SOURCE: push the reset switch
The means that the powerup self test is not completing successfully. If there is no error indication in the viewfinder, this unit will need to see a Panasonic servicer for repair.
Dan
SOURCE: Camera says to push Reset switch. Problem
There are connection issues on your main PCB. We have been successful in solving this issue by repairing multiple connections on the main board and then applying a special antioxidant grease to the connectors. This repair should be done by an experienced technician.
www.austintelstarservices.com
72 views
Usually answered in minutes!
×