SOURCE: safegaurd mode
Unfortunately this is a repair issue. There are several failures that can occur, none of which will be resolved without service, that create this safeguard situation. Often the fpc cable which carries sensor information to the micro has been injured and that requires repair. Good luck, magic seadog
SOURCE: unit in safeguard mode
I have a DVL520U,
I may be lucky from what I have read, but this is what I did. I took out the tape, released the tension on it by pressing the small tab between the wheels (I observed a slight wheel movement). I took the eraser end of a pencil, and while holding the tab, rotated the spindles of the tape 10-15 rotations back and forth (this from the vcr days and tracking problems). I put the tape back in and the problem went away. I thought of this after reading post after post and then finding the definitions of the error codes on a french website. Codes 4-6 seemed to be with the mechanical aspects of the drive, codes 1-3 with the sensors etc. All in all it was a guess on my part. If any of this works for you, pass it along.
SOURCE: unit in safeguard mode
You mix te info with Write protected tapes.
Safe guard mode is caused by the motor that takes the tape out of it's case, through the mechanics and past the video head.
If for some reason the electronics detect that it's been done by too much force, the safe guard issue promts.
SOURCE: unit in safeguard mode
Please remove and reattach battery and hope this will resolve 03 error issue in your JVC camera.
166 views
Usually answered in minutes!
×