White blinking light bottom center

Zoostorm VME50 Notebook

• This unit is identified by White system lights, a white light in the power button, and three symbols lit white to the right of the power button
• To enable the wireless, please press the middle wireless icon to the right of the power button whilst logged in to windows. These three symbols are touch sensitive. After pressing the button, a grey symbol will appear on screen for 'WiFi'. Click this and it will turn green to show it is enabled. The wireless is now enabled.

Good luck.
Semper Fi,
Z

When you press the coffee button , and the top and bottom lights are flashing, that means the grinder is either jammed or out of order. If the machine is less than 2 years old, the service center will replaced it under warranty.

The far left button below the start button (middle, top) is the wireless button. It seems this button is finicky and the led doesn t always light. Open the control panel and access the Windows Mobility Center at the bottom. The wireless feature enable button will not be accessible if the wireless button is not activated. While on this screen press the far left button that has a dish network symbol and keep pressing it over and over until the button on the mobility center panel is enabled. This is the only clue you will have on whether the button is on or off.

Try this...remove the card and battery...press all the buttons...leave it alone for 20 minutes...insert the card and then the battery...turn it on.

hold down the menu button for 20 seconds until the lock symbol turns into an unlock symbol.

I recently replaced a F/R switch and just happened to write down which wires went where so maybe I can help. The front switch ( closest to front of cart) green/white wire to top contact, white/black to bottom.
Middle switch red/white to top, orange to bottom.
Rear switch green to top, black to middle and white to bottom.

It sounds like the hazard light symbol.

Fog lights fuse is #36, which is a 15A (blue) fuse that fits in the bottom "group" of fuses, center row, 2nd from bottom

Are you out of ink? when you open the lid to the printer while it is turned on look at were your ink cartridge stops and that will tell you if you are out of colour or black ink. Which light is blinking the one on top of the paper symbol or the one on top of the ink symbol. It may be that your cartridge either black or white just need to be taken out and put back in I found that if I wiped the bottom of the ink cartridge where sometimes you get build up that it would work again or give it a shake but make sure you cover up the bottom were the ink comes out before you shake it. Hope this helps!

youre in trouble check the other posts