Onkyo TX-SR606 Reciever - 20 sec after power on, screen is green

go to menu and select manual input selection if it is on auto input select

Hello Fixya customer,

Thank you for your question,

There is no LAN connection for the TX-SR606. The available connections include, HDMI, Component, Composite, S-Video, Optical, Coax, and analog audio. The ports that you are referring to may be the HDMI ports.

Thank you for using Fixya.

This unit has a defective hdmi board,this is a common problem with this model. The unit is to be taken to a onkyo service center for exchange of the hdmi board under warrenty, if out of warrentyit will cost you several hundards of dollars.

Are you not getting audio to the television speakers and the onkyo reciever speakers when connected HDMI thru the reciever or just the television. If it is just thru the television then it is because the reciever is grabbing the HDMI audio signal and converting it so it does not reach the TV. If it is both then try changing the HDMI signal output from PCM to DOLBY DIGITAL on the computer. Your reciever may not be able to process the PCM signal of the computer. Does the reciever show a PCM or DOBLY DIGITAL display when HDMI is hooked up to it?

Component (i.e. TV) should be connected to plug labeled IN (signal IN receiver).

Hello, I am sorry about your issue. I suggest that your receiver be looked at by a service center. Thank you. Onkyo USA

You can not have a signal from cable/satelite TV when reciever is OFF.The only way is reconnect by using defferent setup configuration to illiminate the receiver.In that case you well see just regular Tv program but you should connect antena to your TV.

called onkyo about this - plug into HDMI input 1 (DVD) instead of HDMI input 3.

Hi there. for your receiver, the only time it can upconvert is when you go out as HDMI. In your current hookup (component out to tv) the signal from your cable (using a composite) will not be able to pass through the component cable. This means you either have to hook up your cable box using a component cable as well or add a composite cable (yellow) from monitor out of the receiver to the tv. Page 22 of the manual will show a diagram of the video signal flow. hope this helps.. ^_^

try using a HDMI cable connecting the receiver from the "out" to the tv, then allocate through the setup menu what you have connected, say a cable box by hdmi, you would go to cable/sat allocate the port "hdmi1 or coax 1" then return. If it is a dvd click on dvd then allocate eg: "hdmi 2" then return.