Slow making ice. It is taking forever to fill the ice bin. What can I adjust to make it produce ice faster?

that could be one solution. I would look at how long the freeze cycle is lasting. The machine could be cycling off and on via bin stat. Average cycles from start of freeze cycle to start of freeze cycle is usually around 25 minutes or so. If it is taking longer than that, you may have to dig deeper. let me know. Don't overlook a leaking water valve.

I would suggest cleaning the coils below the refrig ( behind the kick plate in front ) or , if clean , turn up the freezer temp slightly to make the ice maker slightly colder .

change the cooling contro indicator to freezer max ..... that will increase the speed of cooling in ur freezer ....

turn the controls to factory settings and give it a couple of days, if it is too cold the ice can not release!!

There is no way to speed it up..
If the bucket is empty - 2 to 3 days to fill is normal..
It takes somewhere around 37 minuets for new cubes to freeze,, then dump.. Cant make the ice freeze faster..

If it has a inline filter on the water line - replace it.. If it is clogged it could slow the water that is going in..

If you-all use allot of ice and empty it before it catches up - I would suggest getting a bag of ice from the store and put some in the bucket to keep the ice level up..

Have a nice day...

I assume you're talking about the ice dispenser and the ice bin being frozen over.
The water inlet valve on the back of the unit where the water supply comes in can have a slow leak and will cause ice to buildup and block the fill tube and causing the water to spill into the ice bin. Disconnect the ice maker line from the valve and watch to see if it has a slow drip. It doesn’t take much to eventually block the fill tube.

If it overfills and drips, look for an adjustment behind the plastic endcover with a +/- on it. - is less water.

It sounds like it is malfunctioning and needs replaced,< the icamaker has a built in heating element to warm up for releasing ice easier, it has probably quit working>.the noise is from it trying to break ice loose from tray without element warming and it is hard to do this.

It should produce about 8 cubes every 2 hours , there is a small door to get to the ice bin make sure it stays closed , If you still have issues you may be expeirencing the begining of a cooling problem.

is the ice too big? if they are, the ice size adjustment needs to be adjusted. if the water to freeze is big then it takes a lot of time to freeze it and ice produce is slow. also you can check the pressure of the water to the ref, it could be very high pressure. i hope i was able to help.

check condenser condition can be dirty, cleaning the coils with coil cleaner for ice machines(i suggest you take all the ice out of bin first) i'd go with that first. check if it works for you.