I have a Kenmore HE2t i keep getting error f21 i cleaned the trap and it still does it

SOURCE: kenmore he2t error code 21

F21 is a long drain...it is taking too long to drain..you have a something slowing down the drain.. you can remove the bottom panel and clean out coin trap... if there is nothing then you may have another problem... but this is the most common problem..

SOURCE: I have a Kenmore HE2T error code F24

The "F24" error code is a heat sensor error code. The following link explains the error code in detail and the steps to correct it:

http://www.fixya.com/support/r1976126-f24_error_code_whirlpool_duet_kenmore

In many cases, the connector plug on the NTC sensor wiggles loose and causes the error code. Check the NTC connection first to make sure it is tight and making good contact. This may save you a service call and/or replacement parts. Make sure you UNPLUG the washer before servicing anything inside the unit.

A replacement NTC module (if required) can be purchased at searspartsdirect.com for about $10. Refer to the parts illustrations under the "Tub and Basket Parts" heading.

If you have any questions, please let me know. I hope this helps you.

NOTE: Each washer comes with a technical data sheet located inside the cabinet. You will need to remove the lower toe panel directly below the door to access it. If it is not located directly behind the panel, it will be affixed to one of the interior cabinet walls. The tech sheet includes all troubleshooting tips, wiring diagrams and fault codes with explanations.