Foreign object in machine - Asko W6021 Front Load Washer

C8 indicates that the lid cannot be locked.
Is the lid closed?
Are there any foreign objects in the lock?
Check that the lid is completely closed.
Check that there are no foreign objects in the lock.
Link to users manual.
http://www.hitachi-th.com/hitachi_new/Download/SF-140SV_EN.pdf

Did you recently break a needle while using the embroidery machine? Check for foreign objects (like part of a broken needle) in the rotary hook. Then press Set to reset the machine. Remember to turn off the machine and then unplug it before doing any maintenance. If there are no obvious foreign objects, the rotary hook may have been damaged by a bent needle. It may need to be replaced.

I hope this helps.

Cindy Wells

see troubleshing routine meantenance chapter in user guide init enable 50

Hi blare131,

I believe there is a foreign object stuck in your Drain Pump Filter, please check it and remove the foreign object.

Please follow my below Tip on how to do this:

ACCESSING, DRAINING & CLEANING THE DRAIN PUMP FILTER...

Kind Regards

JEDEMEYER1

* If this solution helped you, please rate it

Hi.

Access the drain filter and check for foreign objects in there. In this model the access for the drain filter should be located at the front bottom of the machine, behind a trim. Other models have the access at the back. Disconnect power, locate access, remove cap, collect water using a container and check for blockage or foreign objects in there.

Regards.

Ginko

I think the machine is telling you to look inside for a foreign object or scrap of paper:

1) Turn the machine OFF
2) Open the cover
3) Carefully inspect inside for a bit of torn paper, staple, paperclip or other such foreign object - gently clear any problem materials. Do not touch internal parts if possible. Use tweezers for small hard-to-grasp objects.
4) Close the cover, and power ON
5) If the MFC cannot reset itself, or if no foreign material is found, the machine should report an error code, for example "Machine Error XX"
6) From this code, brother support should be able to diagnose and help with your problem

Do the following:

Print Unable
XX
The machine has a mechanical
problem.
—OR—
A foreign objects such as a clip or
ripped paper is in the machine.

Open the scanner cover and remove any foreign
objects inside the machine. ( You might try cleaning the scanner glass.)
If the error message continues, disconnect the machine from
the power for several minutes and then reconnect it.

Try this and let me know what happens. Binary Bob

Check for foreign objects, such as a clip or ripped paper, inside the machine.
Open the scanner cover by pulling up on the lower right corner of the cover. Look inside the machine and remove any foreign objects. If you see jammed paper or another item inside this area, gently pull it out and then close the scanner cover securely

the manual states for this problem
"The machine has a mechanical problem.
—OR—
A foreign obstacle such as a clip or ripped
paper is in the machine."

did you get the solution to the problem u mentioned

the scanner or main circuit board is defective. Give it back to dealer due to warranty.