Schematic diagram
SOURCE: behringer pmp2000 europower no sound
Probably the power amp has arced and popped a lot of components.
When teh amps go usually the final pwer transistors, their drivers and sometimes even the power supply gets zapped.
Check the output of the preamp at the inserts for the final amp with headphones to see if anything is coming through.
SOURCE: my behringer europower EP2500 poweramp has a bad
There is a possible noise build up on your CH2 due to failure or weakness of the LCR network of the preamp circuit. It could also be a noise within any semiconducctor or the preamp IC. Unless you can do a signal test with the elimination of the input to the output amplifier, the fault will not be say to isolate. Hence if youarre familiar do the test by approching from the output amplifier's input, proceeding to the main input where the faulty section can be identified. Hope this helps. Good day
SOURCE: I am trying to find the weight of my Behringer
Weight (net) approx. 15 kg (33 lbs)
You can rate my answer if this helped you.
SOURCE: Behringer amp 240 to 120 volts
What you may need is a
Voltage converter ' Voltage Transformer ' step up and step down ...
Connect the 220V line output to EP2500
And the 110V input to your 110V convenient outlet
SOURCE: Europower Behringer EP2500, clip lights turn on when main power is off
Depending on the age of the amp,there is a possibilty that the amp my have damaged lanes or tracks to the pre-amp section to the front of the amplifier.
797 views
Usually answered in minutes!
×