What is LE error for Washing Machine Daewoo DWF 772W model? how to solve it?

See troubleshooting section of user manual. It will help.

Trouble Shooting - Daewoo DWF-260C Instruction Manual [Page 15] ' ManualsLib

Here is Service Manual for further help
Trouble Shooting Guide; Concerning Water Supply - Daewoo DWF-200P Service Manual [Page 22] ' ManualsLib

Daewoo Washing Machine Error Fault Code = E9
Fault Detected: Pressure Sensor Error
Washer Has Detected: Error with the pressure switch or level sensor
Check / Repair / Fix = Wiring to level sensor - Level sensor

Daewoo Washing Machine Error Fault Codes

https://removeandreplace.com > 2015/11/02 > daewoo-...

Nov. 2, 2015 - The Daewoo generalized error fault codes below are to give you an "idea" as to what part is at fault. ... Daewoo Washing Machine Error Fault Code = E9 ... If your Daewoo Washing Machine Error Code is not listed here, check ... Mine is Daewoo washing machine DWF-8288, showing E1 and won't spin and ...

..

my Daedwoo DWF-806 MP machine when i swith on shows figure 49 and not figure 0, and it also making noise like Buzz in between when the machine is ON. Can anybody help me to resolve this defect
thanks

DWF-200MS I have a DAEWOO DWF-200MS top loader washing machine and when I switch it on I get an error code E9. Can you please tell me the fault and how to repair it?

LE error code refers to the door mechanism. Usually there is a locking switch that senses when the door is closed, allowing the wash cycle to start. If your door is closed and you are still getting the LE error, it is probably this switch that is faulty.

I have a daewoo top loader washing machine ,,

Mode W/M-DWF-200MP

The power main board does not take the programs to work how should be its olny one program

check suis door

I HAVE DAEWOO WASHING MACHINE MODEL DWF-6010AP
THE PROBLEM IS THAT COLD INLET IS LEAKING WHEN RUNNING I NEEDS SOLUTION OR WHERE CAN I GET PARTS

Found the manual for a similar model. LE error code indicates a "Lid Open" error. Most likely the little switch that is tripped when you open the lid has failed due to corrosion or some other reason. If you can find an equivalent switch then replacing it should do the trick. Otherwise, you can simply short the connection so the machine thinks that the lid is always closed. WARNING: This effectively overrides the open lid detection system and poses the risk of having the unit run a spin cycle even with the lid open! find a replacement switch if you can. good luck! just shorted mine out temporarily and it works -- until i can find the right switch.