Its wont charge it says its on usb mode - Motorola Mobility Moto Q

When your phone is plugged Into the computer it barely charges. it is for data transfer only

If you're attempting to charge your iPhone using a USB cable on your computer, check that your computer is not in a power-saving mode. Computer states, like Sleep or Hibernate, do not supply enough power to the iPhone to charge it. Keep the computer turned on and in an alert state to ensure that power is flowing through the USB charger to the iPhone.

Make sure that the USB cable is properly plugged in and use the original cable that came with your player.

Computer in Hibernation mode
Make sure the computer isn't entering hibernation or sleep mode while the device is connected. The computer must be ON in order to charge your player.

USB Port 2.0
Make sure the player is connected to a USB 2.0 port (1.1 occasionally causes charging problems).

USB Port location
Try plugging into different USB ports (i.e. USB port in the back of the computer); occasionally the front USB ports have limited power to charge up the device.

Battery
Make sure the battery is fully charged. It takes approximately 3 hours to fully charge the battery.

Latest firmware
Depending on what Sansa player you have, make sure it's up to date with the latest Firmware.

AC charger (optional)
AC chargers (sold separately) have a 500-1000 milliamp max output, which provides much better charging ability than a USB port. These accessories are available at SanDisk web site.

Hi,
There is a problem in your battery either you need to replace it or you can try to charge it through USB.

If you want to charge your camera through USB follow the instruction:-
1) In the computer turn OFF the hibernate, sleep or stand by Mode. 2) Turn OFF the camera. 3) Connect the your camera to the computer through USB Cable. 4) Wait for your camera battery to charge (Approx. 3 hours)
This may resolve your problem, Else you need to replace your battery

Rating the solution is highly appreciated...Good Luck

There might be a few issues here:

1. Your ipod software needs to be updated
2. Your usb cord is bad
3. Your usb port is not working properly

Either find someone that has a firewire port and update it via itunes, or use someone elses computer to update your ipod's software.

www.huskyipodrepair.com

http://repair-scratched-ipods.blogspot.com

what charger are you using?
if usb
try wall charger as usb wont charge when in restore mode unless the phone is on

No the device is not defective. magellan has this stupid usb interface problem preventing the unit from being charged and used at the same time, they do that so you have to use there charger. the unit will say usb connected and will not boot up like normal at all. unit will be locked up until the usb is unplugged. most usb devices charge at 5v with 500mA, and the magellan requires 5v 1A. Ipod Charger charges at the 1A with 5v but wont work

Hi,

From what I understand you are charging with the USB cable. Did you leave it in at least for 3 hours (the PC also has to be on and not in standy or hibernation mode)? Do the glasses charge with the wall charger?

maybe try changing the usb mode under settings

I was able to get past this problem by removing and reinserting the battery. This caused, in effect, a hard reset of the camera, which let me power it up fresh and take pictures again. Of course, it's not exactly reassuring that the problem arose in the first place,

Jimmo