Camera body can i get Nikon FM10 body only

Release switch needs to be repaired

Hello Blair,
I too like old school camera, mine are the N2000, N6006, N80, and F100. First without film in the camera I would attempt to release the shutter. If it does then there is something going on with the film transfer causing a bind.

However, If it continues not to release the shutter I would put the FM10 on the shelf then go to KEH.com for another. Just now checked KEH.com, 2014-05-26, a FM10 in EX condition is $89, EX+ condition $99. That would be a much better move than repairing yours and less expensive.

Cordially

Not sure exactly which piece you mean, but take a look at http://uscamera.com/fe10-fm10.htm

I can't speak to the FM10 specifically, however nikon has a few standardized positions for the serial number. It may be embossed in in small numbers on the metal at the top back above the film door. Or on the bottom. If you can't find it, I would go to the Nikon USA website. You can e-mail there support department by following this link: Contact Nikon Customer Service Call Nikon Technical Support

This is normal. the lens stay at the largest opening so you can see to focus, then the mechanics will close to the setting when the exposure is made. This is part of the reflex in single lens reflex (SLR). This part staying open when you focus keeps lyou from having to open the aperture to focus and then close it to the correct setting to shoot the picture.

The film lever is also a switch. If you had advanced the film lever, **** it outward a little. You will feel the detent click somewhat when doing so. Leave the lever outward and see if the shutter will work. The detent is for appling an closed circuit for the light meter. When the lever is fully pushed back in it shuts the power to the meter on off to conserve battery power

You have it on timer mode you would take it off that you would be fine

needs repairing at a qualified shop
when was it last cleaned or serviced ?
if you think the camera is worthy, since its old how much is it worth to you vs a new one

When yoo wind your film it usually sets the photo button like a trigger. Any decent camera repair can replace the trigger device that has gone bad then your back in business.

Please take it to a repair shop. They will get the mirror fixed again.