Error f5 in sharp copier ar5316e - Sharp AR-5316 Advanced Digital Imager Copier

SOURCE: add developer in sharp AR-5316

That model uses a TD cartridge so when you replace the toner the developer is included. The crum chip on the TD cartridge will reset the counters and sets the developer.

SOURCE: sharp copier AR5316

H2 or 2H is related to a fuser under heat or overheat.
Try this first,

Performing a Fault Reset 14 will reset your WorkCentre and will help to clear error codes.

1. Find the pink Clear button on the Control Panel of the WorkCentre.
2. Find the button below the word Auto.
3. Press these buttons in the following sequence: [Clear], [Auto], [Clear], [Auto] NOTE: All of the lights on the Control Panel should go out and the LED Display should go blank. If the lights do not go out, then repeat step 3 until they do. It may be necessary to increase or decrease the pace of the [Clear], [Auto], [Clear], [Auto] sequence.
   
4. Press the [10's] key one time and the [1's] key four times to enter '14' in the LED Display, as if you were to make 14 copies.
5. Press the green [Start] button.
6. Press the pink [Clear] button two times.
7. The WorkCentre should now warm up and come to ready.
8. If the above steps do not clear the error code, repeat steps 3 to 6 a second time.

SOURCE: error f2 in sharp copier AR5316E

F2 sub code 00 - Toner Sensor problem, ID pattern reading error. You may have to replace the drum unit or have a tech clean the toner sensor

abbas rezazadeh

• 328 Answers
• Posted on May 23, 2010

SOURCE: sharp copier simulation program how to do it?

I answered it right now

SOURCE: my copier machine sharp AR5316E

remove the catridge to the machine and then insert it back. if it still display the same information the catridge might be damaged need to be replaced.