Gestetner 5308L error says set drum completely

Replace the drum if not possible then go to copy sp mode dial 2208 and change the copier sencer mode to pixels mode

6123 gestetner digital copy printer no salve problum single line on copy. cleane complete scanner and thermalhead,

sc360 is a hard drive detection error. The hard drive might be either defective or disconnected, or one of the connectors might be loose. If you know the hard drive is good, check its power and data cables and connectors. In rare cases, this error can point to a faulty BICU board.

sc990 is a general software error. This error is often logged in conjunction with other errors, and may not necessarily represent a separate problem.

Your best bet is to check the hard drive first -- maybe try formatting it or replacing it if you have an extra one. Good luck!

take all paper out. check to see if any paper is jammed in the rollers
go to application folder for your computer, dbl click icon for make of printer, for settings, check to ensure everything is order.
lastly, check make of printer trouble shooting web site for more information
hope this helps, good luck.

SC05-52
Clamper open
position sensor
remains on when
opening the
clamper
At the master clamper open
timing, the sensor is not deactivated
for more than 4
seconds after the clamper motor
on signal is generated.
• Defective sensor
• Defective motor
• Jammed drum guide
drive
• Defective 2nd drum
position sensor

In short check the sensor

input checks SP

4-042 Master Set Sensor
4-043 Master End Sensor
4-044 Master Edge Sensor
4-046 Platen Release Sensor

make the reader option is enabled in the server application
there should be 4 applications running

Turn the main power switch off
then on before entering SP mode.
Reset the SC (set SP5-810 to 1),
then turn the main switch off then
on again.

replace drum blade

You have an improper black toner density. Likely your black toner suction mechanism is clogged or the black toner supply clutch is not working.