The dryer will not start duets damp dry signal being on and must use a fan to dry the dryer outpost art again
SOURCE: Kenmore Elite quiet pak 9 dryer
Error message E1 indicates the temperature thermistor has failed.
SOURCE: clothes still damp after running a cycle on auto moisture setting
Clean the vent hose and vent outlet
SOURCE: Kenmore Elite dryer heats but does not dry
Make sure that your vent tube is not kinked or crushed behind the dryer and it all this is ok then you need to change your cycling thermostat. is it gas or electric
SOURCE: kenmore dryer is hot at start of cycle but clothes
most likely you have bad gas coils?if the dryer runs correctly for the first 15 to 30 minutes and then no heat it's the coils,when they heat up they fail and when they cool down they'll work again for a time then they will die,the coils are on top of the gas valve,change them out one at a time and you should have no problems,remove the 2 screws lift up the metal top and change out the coils
SOURCE: Dryer turns on and rotates. However, does not dry
This problem may be the result of a dirty lent filter which if clogged will short cycle the dryer and the clothes will still be damp when done. Also a dirty exhaust pipe (usally 4") will prevent the clothes from drying correctly. Make sure that the air is leaving the machine. To do this you have to go outside when the machine is running.
Testimonial: "Thank you. I will check this"
187 views
Usually answered in minutes!
×