What does error c58 mean - Frigidaire GLTF2940ES Front Load Washer

The "F1" error means that the dryer's thermistor failed and needs to be replaced. Make sure you check the dryer vent for clogs before installing the new part.

http://www.epson.co.in/epson_india/support/eol_product.page?support_name=Epson_Stylus_C58

Bit late to respond but in terms of information this page helps explain the problem, cause and what you can do about it.

Resetting will allow the printer to start working again but you do need to consider what you intend to do regarding the waste ink building up in your printer as well, or you risk an overflow.

Printers and faxes then highlight printer then go to file and select set default printer. Then open printers and faxes go to file select restart

You can reset the waste ink counter using
http://tricks-collections.com/2008/09/resetter-epson-c58-c67-c79-c90-r270-r390-rx650-cx3900/

The generic SSC utility is also available at
http://www.ssclg.com/epsone.shtml

However, remember ink is still accumulating in the waste ink reservoir and will eventually start to leak out. To replace the waste ink pads you need to disassemble the printer.

A free copy of the service manual is available at
http://www.filestube.com/2572254e26edfe0a03e9/details.html

Turn off the printer, gently push the ink carriage all the way to the right side (LCD and buttons side) by hand. Turn on the printer and mine was back to normal. Hope that works for you all. Cheers, Bizytrading.

Check all of your fuses on the power supply.

Go here:http://www.kenwoodusa.com/support/simple.aspx?men=2&M2=69 or go to their support page located at the same site. Good Luck

you can simply and easily replace 3 capacitors on the main amplifier board (c58 - 47uF 63v or 100v) + (c52 & c53 - 220uF 25v) but stand them away from the board on the length of the capacitor leads to prevent them from absorbing heat from surrounding hot components (with heat shrink tubing to prevent shorting)

these are usually the cause of most problems with KEF PSW subs, as for it sounding wooly, this is just the way it is, mine is the same.