Triumph 400 t dispays e1 code

try google with model# and the error code

Might be the power supply. That's about all I can think of. It runs but gets hot very fast and shuts down

Remove up and down liver moter cabel in mother board. And restart machine. Now ok e1 error.

E1 usually suggests it is and Electrical error and would probably require someone with knowledge of treadmills to rectify the error.
It is very unlikely the ordinary Jo Blo can fix this problem.

ERR1 indicates a speed issue. In this case, the motor speed as reported from the optic sensor differs

from the speed setting.

Analysis: Optic sensor signal issue -- Either the optic sensor signal is not right, or it is read incorrectly, or

the signal is not reaching the display.

Test it for open or faulty+ clean it, and tight vbery well the connector, see the diagram adjust it

Try to run the software calibration for troubleshooting and diagnostic too.

God bless you

As said in the question you are haier washing machine keeps stopping and displaying error code E1 this is due to the Error signal due to Pr. Sensor.This problem can be solved by only service Engineer.Thanks for your question.

E1 is a code that the dishwasher displays after detecting a leak. There is a sensor on the pan at the very bottom of the unit. Take the bottom front panel off, look under the unit at the hose coming off the pump and your fill line to be sure no water is dripping. Run the unit in a wash cycle while doing this if possible.

i have canon ir405 cpier it dispays error code E243 please help me sir

E0064-001