Question about Washing Machines
Fluff may have blocked the filter or jammed the drain pump. you need to check these
Posted on May 31, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
e47 i believe is a door lock issue, although its locking shut there are multiple switches in the lock mechanism
Posted on Feb 23, 2008
SOURCE: f21 code on kenmore he2 plus
Clean the filter in the pump behind the bottom panel,but remember it's full of water,If it's on a pedestal you can take the pump loose from the mounting pull it out a little and put a small pail or bucket under it before you open the trap.if it isn't on a pedestal it's a bit more challenging unless your in a basement with a floor drain. Open it very slowly and let the water drain a little at a time don't take it all the way out or you'll be in for a flood....good luck
Posted on Sep 03, 2009
"F21" is a Long Drain error code. This indicates that you have an obstruction in the drainage system. In most cases, this means you probably have a clog in the drain pump. The following link explains:
Rugs are notorious for losing fiber and holding loads of dirt. You may have something getting caught in the pump impeller and slowing it down. Included is a follow-on link that explains how to check the drain pump to clean. You may also have to remove the inlet hose that runs from the bottom of the wash tub to the inlet side of the drain pump. Debris can commonly clog in this area as well causing the drain cycle to fail.
If you have any questions about this repair, or need additional assistance, please let me know. I hope this helps you.
NOTE: If these preliminary measures do not correct your problem, you may have to replace the drain pump. It does not take much to damage the pump impeller or motor. Since the error code is generated if the drain cycle exceeds 8 minutes, if the pump is damaged and can't pump at the required volume, the error code will continue to appear until the pump is replaced.
NOTE: The "SUDS" error can also commonly occur with the F21 error code as this is usually generated when air is sensed in the drainage system.
Posted on Oct 15, 2009
Tips for a great answer:
Dec 06, 2015 | Kenmore HE2 Plus Front Load Washer
Jan 09, 2015 | Kenmore HE2t 3.7 cu. ft. Front Load Washer
Mar 19, 2014 | Kenmore HE2t 3.7 cu. ft. Front Load Washer
Jul 29, 2011 | Whirlpool Cabrio WTW6600SBT Top Load...
Sep 23, 2009 | Kenmore Washing Machines
Jun 13, 2008 | Kenmore 24032\24036 Top Load Washer
Dec 29, 2007 | Washing Machines
Nov 17, 2019 | Washing Machines
58 people viewed this question
Usually answered in minutes!