Frigidaire Front Loader LTF2940ES3 does not fill.

All front loading washers will fill and drain multiple times before it finishes. Unlike a top loader, a front loading washer will take longer to run because there is no agitator and will fill with water and drain multiple times. A front loader is more energy efficient than a Traditional top loading washing machine. A washer dryer combo will take hours to complete a cycle.

Empty the machine. Turn off. Close door. Try pushing simultaneously 2 buttons at a time while powering up. This would reset the machine.

This is typically not a DIY type of job since the entire front, top, panel where the settings are needs to be taken apart to reach the control board and wiring harnesses.

water pump is clogged i pulled it out and cleand it and put it back and its working like it should and the part n is m222-5 on the frigidaire front loader

Take a look at this page.

ok take the bottom panel off theres two screws,,almost to each corner,,,always unplug first...ok check your pump its on the left and has two black hose,,clean and,,reverse to put together...onthejob..the top panel with door cant be removed

it fell out of the dispenser, hold the dispenser facing away from you on the left side there is a small slot, place the magnet in vertically so the long side of the magnet is on the right when looking from the front with the drawer closed good luck

the max wight will be given in your book - usually about 5kg

Replace the water valve and your problem is gone.

Are you sure that water fills the tub ? Close the hot water tap and check if cold water fills in, then close the cold water tap and open the hot water one and check whether hot water fills in. Let me knw with your test results.