Maytag model m6p09s2a portable room conditioner owners manual

It sounds like the compressor is not running. This could be due to a faulty thermostat, a bad start capacitor for the compressor, a bad compressor overload or simply a bad compressor. You would need a voltage meter to check all of these components.

I believe you'll find what you need at the following link. http://www.appliancefactoryparts.com/airconditioners/maytag/m6p09s2a.html If you can't find it there, try Sears Parts Direct.

I hope this helped you and thanks for choosing FixYa.

Mam, you don't put any water in it. This A/C Unit has a dehumidifier in it, that takes humidity/water out of the household air, which helps make the room cooler.

Greetings,

I have the same model air conditioner, and had the same symptoms. As you've probably discovered, Fedders is the company that actually built it, and went of business. No one is supporting it any more.

However, you may be in luck. I fixed the problem by simply tipping the unit almost all the way over on its back (leave a little gap) and letting the water drain out of the hose and the filter. After that, it started right up.

Hope that works for you. Stay cool. :)

it should freeze that room with 9000btu do you hear the compressor turning on or is it blowing jus air? also helps if you switch the air intake to recirculate the room air rather than intaking the air from outside

I fabricated my own vent duct partition out of a plank of 1 X 8 pine. I primed it, painted it and sealed the air gaps. Works great, and looks good!

I called the service tech, before Maytag stopped supporting this unit. (built by Fedders with Maytag name). Fedders has gone out of business (7-09). The tech guy said that the tray gets clogged up with crud and the solution is to try to flush the tray out with water and compressed air. I had the problem of water leaking from the trays but not properly draining through the drain hose. This solution did the trick.

I have the M6P09S2A Portable unit that is leaking water everywhere. I have to place it in a large bin to keep it from draining on the floor. Any solutions?

After much research, you are going to have to call Maytag. Here is their contact info.
http://www.maytag.com/support/contact_us.jsp

Call an electrician . Sounds like you are pulling too many amps. I wouldn't even run the fan....