There is not enough water in each load - Frigidaire GLTF1670A Front Load Washer

No cannot over ride set at large doe the machine fill to a certain level then stop if so operating correctly if it never stops filling with water then there is a leak in the fill system either a hole in pressure switch hose it popped off tub or water leaking out thru drain system pump or siphoning thru hose again if unit starts to agitate there is enough water in unit per design

The water level is controlled by a pressure switch connected to a long rubber hose that goes inside the tub. If the switch is defective or if the pressure hose is blocked the machine may under-fill.

Check also inlet hose and water pressure from the house.

Fill setting has to be adjusted and the belt is slipping on the spin cycle and not generating enough centrifugal force to get the water out.

Front load washing machines are better than top load money wise.

One advantage of a front loading washing machine is an increased capacity. Since there is no central agitator, the horizontally-oriented drum can hold at least 20 to 30% more clothing per load. For a large family, this could mean running only three loads in a front loading washing machine compared to five in a top loader. Fewer loads often translates to savings in utility bills and water usage.

Another advantage of a front loading washing machine is less water and detergent usage. A top loading washer must use enough water to cover the highest level of the clothes. A front loading washing machine, on the other hand, only uses enough water to cover approximately the lower third of the tub at most.

FRONT LOADING OR TOP LOADING ??

If its a High efficiency washer it doesn't use much water. Usually the front load washers are HE washers

Did you sort properly? sort lint givers(towels) form lint takers(syenthetics)

did you over load the washer? the wash load must be balanced clothes should move freely in the water

did you select to correct water level?

did you suse enough detergent? use enough detergent to hol the lint in the water

Did you line dry your clothing? if so you can expect some lint on clothing?

check the following:
was paper or tissue left in the pockets

is your water colder than 70 decrees F washe water colder than 70 decrees may not completely dislolve detergent

did you use the proper cycle time for the load? reducing the wash time is another way to reduce lint

A - Two things could be your problem...
1) - sometimes the screens in the fill valve or inside the ends of the fill hose get clogged up...use a tooth brush to clean them out. Don't forget to shut off the water first before removing the hoses to check for this.
2) - The fill valve itself may not be opening fully = time for a new fill valve.

Check your filter,and see .!!!water may not be pumping out fast enough!!

Be sure you are using HE detergent and only about 1 Tablespoon for a load. You are ending up with too many bubbles in the machine and when it goes to spin the bubbles come out the air vent. There is a valve that closes during spin but bubbles are not strong enough to lift the valve it has to be water hitting it before it closes.