Where can i get byron sx1 wireless push button brass look from ?

https://www.homedepot.com/p/questions/Heath-Zenith-Wireless-Battery-Operated-Doorbell-Push-Button-Black-and-Satin-Nickel-SL-7303-02/100626792/2

I found this in the Questions

Q:Hello, I need a wireless doorbell button replacement for the Doorbell model: "desa sl-6180-rx-a". Please, help. Thanks byTim'May 31, 2020

1 Answer A: Hi Tim, Any of our Heath Zenith or Hampton Bay branded buttons will work with that model. You will need to put it in backwards compatible mode. Please contact our technical service team and we'd be happy to help.
byHeathCo'Jun 2, 2020

Also sold by Heath Zenith and where there Product Support is.

https://heath-zenith.com/products/wireless-push-button-sl-7797

..

contact Byron.

check the batteries if it has batteries and the connections and the distances

Do you need to replace the batteries in the chime button or the receiver? To change the batteries on the doorbell (chime button) for most Carlon models, you need a ballpoint pen first to remove the chime button from the back. Press the pen point in the small round hole at the bottom of the button. Then gently push in on the tab. Finally rotate the chime button cover up and away from the back cover. Next take the ballpoint pen or a small screwdriver and place it in the slot below the top battery. Lift the battery up. Repeat this with the second battery. Then place the replacement CR2032 batteries into the battery compartment one at a time with the positive side up.

For the most of the wireless receivers, press the center of the brass tubes and lift those free to replace the 4 D cell batteries (2 behind each tube). A few models have a more obvious battery cover for a set of 4 AA cell batteries.

Many Carlon wireless chime manuals are available here: http://www.lamson-home.com/WirelessChimes.php . The direct link to the manual listed for the RC8800R is http://www.lamson-home.com/ProductSupport/WirelessChimes/RC3304_4300IM_3.06_v2.pdf .

I hope this helps.

Cindy Wells

another byron wireless door chime , the same model as what you have got

Wireless signal is short range

Hi

To fix the issue you need to remove the batterys from both the bell push and the bell unit for 10 mins, then replace the batterys and then push the bell push so it can switch channels and be different from the house down the road

The doorbell buttons and your receiver must be on the same channel. If you will get out the directions that came with your unit, they will describe the process to go through to reset the specific "codes" for your buttons and receiver.