What does e27 mean

Try restarting it, make sure the load isnt to heavy, if that does not help, call a local repair man.

A code E27 means a problem with the door lock. Try unpluging the machine for an hour and see if it resets the lock.

If not remove the cover on the lower right corner you will see a white plastic pull cord. Pull the cord and pull open the door. If that doesn't reset the door lock you will need to replace the lock.

Hello zabbster - Typically the DR or DO error code indicates that the door switch is not closed. Make sure that the door lock is completely closed. If the door is closed, make sure the door latch is not broken. If the latch is broken, you may possibly need to replace the door lock switch.

E27 means there is a problem with the door lock. Unplug the machine for 5 minutes and try again. If the error code returns you will need to replace the door lock assembly.


If you have anymore questions please comment me back.

The E27 code isn't often listed in Bosch manuals but relates to the washer door lock.

The E27 error flashes on the washer LCD screen and stops the current load. Unplug your washer for 30 minutes and then plug it back in to reset the code.

Open and close the door two or three times to reset the sensor. Sometimes the door has been closed too hard and the sensor reading fails.

You may need to replace the door lock assembly on the washer.

E27 means there is a problem with the door lock.

Unplug the machine for 30 minutes and try again. If the error code returns you will need to replace the door lock assembly. Open and close the door two or three times to reset the sensor. Sometimes the door has been closed too hard and the sensor reading fails.

Replace the door lock assembly on the washer. Refer to your washer manual for the correct part numbers.

Check to see if your Bosch washer is still covered under warranty. If so, you could receive free replacement parts and service for the faulty door locks.

Hope this helps (remember to rate and comment this answerr).

LOC stands for lock....door lock failure....check the door strike and make sure door is closed....if closed wil need to replace lock mechanism

are you getting three beeps when trying to start, if so door lock problem

dr code means door not closed
get some crc spray and spray into lock on machine
that will lube the workings and should fix problem

It sound like a lid switch problem .A defective lid switch will notice of an open door when actually door is physically closed, and will prevent washer's spining and function at all. The switch located inside the machine near the door frame. You should open the top panel (open 2 screws and then slide it out) and you will have an access to it . You can test it by multi-meter (it is an on/off switch). In case of a deffective switch, it should be replaced. Be aware that you should remove machine's power cable before starting your test !!!! Good luck !!!