On my lx 90 LNT the DEC wheel came off, unable to reattach...?

Whirlpool/Kenmore Top-Load Washer Disassembly - YouTube

? 4:08
https://www.youtube.com/watch?v=j8_TzloPCwY
Dec 6, 2012 - Uploaded by RepairClinic.com
Repairing a Whirlpool/Kenmore top-loading direct drive washer? ... Whirlpool Washer Repair & Diagnostic ...

Whirlpool / Kenmore Washer - How to Remove the Outer ...

? 1:49
https://www.youtube.com/watch?v=vogysB7XOc8
Jul 14, 2008 - Uploaded by Bill Newberry
This video shows you how to remove the cabinet on a Whirlpool, Kenmore or ... Whirlpool/Kenmore Top-Load ...

Hi
As this is not a UK model we're unable to help - we recommend you contact [email protected] for assistance.

Probably just needs a new lithium coin battery - located behind front panel.

Since you already disassembled the scope-- you can send the board to Ron Sampson and he should be able to repair it. He fixes main boards and hand controllers (including the screen and keyboard on the hand controller!)

If you post a message on the Yahoo LX90 group looking for Ron Sampson he will answer you. You can then email or phone him for instruction on how to send him the board.

ARE YOU SURE it's the board? It could be a bad keyboard or a bad cable on the hand controller. You should get another hand controller and cable and test it before you send it off. Can you borrow a hand controller and cable from anyone.... or from a local scope retailer?

If you will post this question on the LX forum on:

www.cloudynights.com someone will know the proper sequence and color to reattach.

Go onto www.cloudynights.com and post this in the LX member forum-- and or go on YAHOO groups and post this in the LX90 forum--

Are you absolutely sure that your TIME and DATE and DAYLIGHT SAVINGS (yes-no) are correct.

On my LX90 the first alignment star is always NOT in the eyepiece but everything is OK once I center both alignment stars.

A little bit of logic

You should be able to get parts from Meade.

I have an older one, without electronics just a tracking motor, and that one has a positive polarity tip.

One thing you can do is to completely reset the controller and reinput everything back into it.
If that doesn't work then you need a new hand controller.

It would be nice if you can take it to a local telescope shop and have them try your controller on one of theirs.
Tom Net