How to change dryer belt on Asko 7305 dryer

I think you are asking if you can change the cord from 220 amp to 110 amp so you can use a 110 wall receptacle...NO you cannot not.It would also probably start a fire

I've had luck vacuuming the lint and dust out of the humidity sensor on my Asko. Suggest trying that first. While you're in there you might also exercise the connectors at the circuit board end of the sensor's cable(s). If they're corroded, some simple unplugging and replugging a few times might burnish the connectors. I've observed that our dryer will sometimes run longer than necessary on days when the relative humidity is high. Not very often but enough to suspect a trend. If your environmental air is humid, I would wonder if you're experiencing a similar condition. Every couple of years I take the dryer outside and blow it out with the air compressor: air chamber including heater coils as well as all the innards. This also gives me a chance to keep an eye on the belt!

What fuse? There are more than one.

Assuming that you need a 220V connector, they can be purchased at home Depot. They are generally made with about three feet of cable attached. you will have to take the back plate off of the dryer and attach the three leads to the proper termination.

Hi,

Here is a tip that will help you with changing your dryer plug.

Dryer Cord and Wiring Dryer 3 Wire or 4 Wire

heatman101

Hello Susan, Welcome to FixYa. Have you checked to see if perhaps one or both of the fuses may have blown at the back of the unit...I don't mean the hi-limit that you already referred to...I mean the in-line fuses the Asko machines are equipped with. Let me know and we can move forward from here. Regards, Macmarkus :)

Problem was solved by pushing the very hard to find black reset button in the center of the back of the dryer.

Go to repairclinic.com the part you need is around $15 and the shipping is good on that site I have bought alot of items from them and are great dealer .....

make sure that the heating element is not shorted to the cabinet. Usually when you replace the hi limit you should replace the thermastate along with it. What is the brand of the dryer?