Sign in on toshiba moves to start but arrow disappears so it wont work

Go to the Control Panel, using the menu (keys control+ESC).

Using the arrow keys.

Using the tab keys go to mouse icon and then pointers and make the changes to reveal the cursors.

make sure your ram is upgraded to max capacity
see
http://www.crucial.com/systemscanner/

DDR2 PC2-5300 2x2gb chips



update windows including ALL optional updates

Hi,
Go to bios setting first( click "F2" ) to see if your laptop can still reads the memory,hardisk and sytem.
Click maximum default operation and save on exit.
Tell us afterwards to guide you further if that did not helped you.
Thanks for asking FixYa!

hi friend

Press F8 Just after you press the power button.
a window will open select safe-mode use the arrow keys to select and hit enter .then safely restore the computer using system restore.or uninstall the graphics Driver from control panel.the drivers that you were going to install was digitally signed?
this thing usually happens when you install an unsigned driver . click her to know hot to use system restore

please rate me

Run check disk for hard drive errors. I recommend immediately backing up all your data that you can, wiping it, and reinstalling your programs. The rebooting problem smells like a bad hard drive. I just went through it with a Compaq at work.

First thing to try is to pick up handset or place on speaker. On the answer machine itself without trying to call your cable providers voice mail service...press the message button to ensure all messages have been heard or erased.
Second, unplug your phone power from the wall and wait two minutes before powering on the phone.
Last replace batteries in the phone if you have batteries in the phone now...may be low battery signal.

Could be the mouse lock key. I am unsure as to which key it is on yours. Mine is the F9 key. it will have a picture of 2 mouse on , 1 with a no go sign over it (circle with a diagonal line through) try pressing the "fn" key and F9 and see if this unlocks the cursor.

check your device manager and see if there is a problem there
to get there go to
start/control panel/performance maintance/system/hardware/device manager/mice. click the + on mice then right mouse properties and make sure the device is working properly and that it is enabled. then go to update driver and see if it will update
good luck

Sounds like you are in close caption mode.
press the menu button and use the left and right arrow keys to highlight the 'closed caption menu"
press up or down arrows to select

navigate to closed caption off and highlight
the box should disappear

Download the user manual here:
http://www.devicemanuals.com/downloadguide.php

closed caption features start at page 30

format the system and re install anoyher o/s