I can't pair my iphone in YouTube. I used to have it before but I lost it and now I can't pair it. What will I do to bring it back?

First, I'm not a Bluedio Tech.
* Review and setup; https://www.youtube.com/watch?v=3ko3U4WCsEU
* H-Turbine problems; https://www.youtube.com/watch?v=q7nWp9YVqYI
* iPhone 5 & 6 pairing; https://www.youtube.com/watch?v=mU2NJ58kRbM
* H-Turbine pairing; https://www.youtube.com/watch?v=tORq3XkX4_c
* Phone pairing; https://www.youtube.com/watch?v=SSpqmbI0Jso
* Final, check your warranty, call for service and support.; https://bluedio.com/

Aloha, ukeboy57

Pair your device with a Bluetooth accessory

1. On your iOS device, tap Settings > Bluetooth. Stay on this screen until you complete the steps to pair your accessory.
2. Place your accessory in discovery mode and wait for it to appear on your iOS device. ...
3. Tap your accessory to pair.

Set up and use third party Bluetooth accessories

Try pairing again.

TX550 Bond Pair

Be sure Bluetootis enable on your iPhone when you search for your tx550.

Mark
Motorola Support

I recommend turning the Panasonic back to pairing mode. It probably came with instructions on how to do it.

One has nothing to do with the other. Pairing will affect only the connection between the laptop and the cellular phone which are probably using bluetooth to connect to each other. Neither should have a remote. You are try do to the equivalent of adjusting you refrigerator temperature by turning the oven on just because it is also in the kitchen, it makes no sense.

You need to reset the Parrot first.

Hold down red and green buttons together until she tells you that the memory is being cleared. Then she will prompt you to pair your phone.

Then, and only then does the Parrot allow the iPhone to pair, and it will bring up the code prompt for you on the iPhone.

You won't find this written down anywhere on the Parrot site.

My iPhone 3G is now connected. Did 3 things:

1. Deleted every existing paired device on the Parrot CK3100.

2. Pressed all 3 buttons at once. Parrot CK3100 screen lit up and buttons lit up after about 5 secs. Turned car engine off. Parrot switched off. Turned car on again.

3. Went to settings, advanced settings, pair device (and also switched on iPhone bluetooth) and tapped Parrot CK3100 on the iPhone screen (which had now appeared) - phone connected.

After about a minute sync iPhone phonebook appeared on Parrot.

Hope this is helpful.

Calm down. Could be a number of things causing lost service. Restart the PC with iphone disconnected. Bring up itunes, plug in iphone and let the activation sit for a couple of minutes. If status does not change about sim card, eject the sim card using a paper clip, insert that paper clip into the tiny hole on the top of the phone. disconnect the phone, insert the card again, and reconnect. Let me know if this helps.