Jenn-Air JCD2389G Side by Side Refrigerator Logo

Related Topics:

A
Anonymous Posted on Jun 14, 2014

Why my Jenn Air JCD2292KTB side by side is not dispensing ice:

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Mar 26, 2008

SOURCE: Jenn Air JCD2389GES ice dispenser problem

my ice maker is not making ice.

Ad

Anonymous

  • 3422 Answers
  • Posted on Apr 05, 2008

SOURCE: ice maker doesn't work. changed filter. light on ice maker door still on.

Hi,

Just check THIS link out.It will solve your problem.
From my side i believe it is the control board which has to be replaced and it will work again.

Goodluck..

Anonymous

  • 1036 Answers
  • Posted on Jun 11, 2008

SOURCE: Rust on Jenn Air Refrigerator Door at Water Dispenser

You may end up respraying the door, but here goes.-

First mechanically remove as much of the rust as you can with an old screwdriver or similar scraper. Then use coarse emery cloth - 80 -120 grit untill all you're left with is shiny metal with rust pits.
You may need to go out further than you think - about 1" all round.

Then use a paint- on de-rusting fluid from vehicle products supplier. When all rust is black or dissapeared, use a zinc primer on all the bare metal. (this will stop it reacuring)

Then either spray the area with an "appliance white" aerosol or squirt it into the cap, and use a paintbrush.

If you are spraying it, open all house windows and doors, cut a mask from newspaper- then tape it to the fridge. Use blankets , plastic dustsheet or old sheets to protect things, and spray it from 12" in several very light coats.

When done, "polish" with T cut - which should remove the rust stain too.

Seal the area of the original leak with a white or clear silicone - and sort the original leak out.

If you polish the plastic with a silicone spray, water will tend to stay put rather than seep.

Anonymous

  • 1 Answer
  • Posted on Jul 15, 2008

SOURCE: Jenn Air JRSD209T

This is just anecdotal here, but one repair guy who came out and thawed a frozen line into the icemaker told us the fridge required near-full line pressure 90- or 70- or whatever that is, in order for the ice maker to work. This was a licensed repair guy. We were feeding it with an RO, which only pumped it in at 17 or 20 psi (or whatever the unit is) which he informed us was inadequate. However, after he thawed things out and we changed out the inline carbon filter in the fridge, everything was hunky dory for a couple of years. About a year back, the icemaking stopped, and changing out the carbon filters in the fridge AND in the RO system did the trick.

Now we have a different problem. Things aren't getting or staying cold, especially the fridge. I opened the housing in the back of the fridge, defrosted the extensive ice accumulated around the refridgerant coils, and everything ran great for a couple of days. Now we're back in the global warming pattern: steadily rising temperatures and thawing. I'm not feeling too happy about Jenn-Air these days.

Anonymous

  • 1 Answer
  • Posted on Feb 13, 2010

SOURCE: My Jenn Air refrigerator ice maker quit working

My Jenn-Air refrigerator (JRSD2790) quit making ice, dispensor works, water dispensor works. Do I need to replace the entire
ice maker?

[email protected]

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

What is freezer and refrigerator temperature suppose to be set on

If you want to set the temperature your Fridge/Freezer should maintain, you need to set the Freezer to between -19c and -23c, however if you will be keeping Ice-cream in this freezer then it's best to set the base temp @ -21c minimum, -23 preferable, or the ice cream may begin to break down (very slowly I might add). The Fridge needs to be set to a maximum Highest temp) of 5c, any higher and the food will not stay as fresh and bugs will be able to breed, preferable temp is approximately 3-4c.
0helpful
2answers

Ice maker doesn't work. changed filter. light on ice maker door still on.

You need probably to change the dispenser solenoids which swith water on dispenser
0helpful
1answer

Model JCD2389GEW - ice/water dispenser does not work. Until recently, it did not do anything on any of the settings (water, cube and crushed ice) now it crushes ice on all three settings but the door does...

We have a Jenn Air side by side, model JCD2389GEW. The ice dispensers work, the water does not. This started after I replaced the filter. I've checked and nothing is locked out. When you press the actuator pad to dispense water, you can hear a noise similar to a small pump which I assume is a solenoid attempting to open. Any ideas?
0helpful
1answer

Jenn-Air refrigerator is not making ice but it's dispensing water

It can take up to 24 hours for a new ice maker to make ice.  Check it tomorrow.
5helpful
1answer

My Jenn Air refrigerator ice maker quit working

My Jenn-Air refrigerator (JRSD2790) quit making ice, dispensor works, water dispensor works. Do I need to replace the entire
ice maker?

[email protected]
0helpful
1answer

Jenn-Air JCD2389GEB - Water dispenser

Our water line looks to be abut vertical...
1helpful
1answer

Ice and water hook up for Jenn-air JSD2789GEB

The water coupling is usually located at the bottom rear of the Fridge and will require an installation kit (easily obtained at your local Home Improvement Store) and tapping into an existing copper cold water pipe (the kit will/should includes the line tap).
0helpful
3answers

Jenn Air JCD2389GES ice dispenser problem

You could have a layer of solid ice at the bottom of your icetray. Remove icetray. Remove any ice in bottom. Reinstall. Be careful there is a connection on the rear of the icetray, you may have to turn it to get it to mesh correctly. Fill with ice and it should work fine. Good Luck.
0helpful
1answer

Water/ice maker not working and freezer/frig not cooling evenly(top warm/bottom cool)

the relay valve that controls the water is stuck.
likely hard water deposits,
0helpful
1answer

Jenn Air Side by Side Refridgerator

You could have a layer of solid ice at the bottom of your icetray which is binding everything up. Remove ice tray and any ice from the bottom. Reinstall and be careful of the connection on the back of the ice tray, you may have to turn it a little to get it to mesh correctly. refill and try. Good luck.
Not finding what you are looking for?

144 views

Ask a Question

Usually answered in minutes!

Top Jenn-Air Refrigerators Experts

john h

Level 3 Expert

29492 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Jose Ramirez

Level 2 Expert

264 Answers

Are you a Jenn-Air Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...