How do you put chair in neutral so it can be pushed

IT NEED REPAIR , GEAR SHIFTING IS BAD.
FIND A SHOP AND GET IT FIXED/
MOVED THIS FROM CARS TO WHEEL CHAIR ELECT.

make sure the charger is disconnected from the chair. turn the power on, then push the horn button twice in row, within ten seconds of starting the Joystick. This will reset the lockout. Push on the chair to see if both motors are in the parked position, if one side moves then that side is not locked. both sides need to be locked in order for the chair to run. Strege Mobility

I’m happy to assist further over the phone at https://www.6ya.com/expert/bill_bcbb89783b08c489

Chair is in the neutral or freewheel position to allow for pushing the chair. Place each motor in the drive position and turn chair on again.

On the back of the chair, there is a lever that dis-engages the drive motor to allow you to push the chair.

I assume you have deep cycle Gel or AGM batteries. Looks like you did not break in your batteries properly. It takes 5-6 full charges to get them up to 100%. Many experts say that you should never unplug your power chair and to always store it disconnected with a full charge, in a warm place.

If the battery is dead,it is unsafe to jump it

AGAIN --- DO NOT JUMP A DEAD BATTERY

Put a battery charger on it

You may have a battery with a dead cell which is keeping your chair from charging right.

If you have a load tester on hand ,load test both battery's they should show the same
if they dont show the same this tells you the one that fell to a lower reading is your dead cell battery make sure when you do change out the battery's you change both.

Good luck hope I was helpful

Tech

Yes. Put the chair in neutral by displacing the levers attached to the motors, and push it slowly to where it needs to go. NEVER push it with a vehicle as the computer onboard will sense an overspeed in neutral condition, even if the chair is off, and start braking, then emergency braking. Push at a normal walk pace.

If the battery is dead I would have the batteries load tested. Let it charge 12-14 hours. To operate the chair push the power button and push the joystick in the direction that you want to go.

Make sure the charger is unplugged from the chair and that the chair is in gear. There's two levers that place the chair in freewheel, or neutral so you can roll it around. Place these in neutral, then back in gear firmly. If still flashing, turn chair off, wait three seconds and turn back on, then push on the horn button three times. This will take it out of sleep mode. Still not going, you will need to check all clip-on connections to make sure they are tight.

I am assuming that all of the lights are flashing constantly. If it flashes a "fault code", you will get a series of flashes from 1 to 10, then a pause, then a set of flashes. Count the number of flashes and it will tell you what the fault is for that number of flashes in the owners manual. If it is just two red lights flashing constantly, you have a set of dead batteries.

Good luck.