Zebra 90 error keeps saying paper out - Zebra 105SL Thermal Label Printer

Paulo Rangel

• 285 Answers
• Posted on May 08, 2008

SOURCE: Zebra printer problem

chek on setings if the sennsor is reflective, transmissive or auto.
should be on Auto. try to read the Sensor profile, and check if read the gap.
Try the Manual calibration, and then run the sensor profile.
tur off and on again.

SOURCE: My Zebra Zm 400 keeps saying Pause Error Condition

make sure that the maximum lenght for the label is set to something greater than the physical length of the label. I was having this issue with a 4x3 label. As soon as I increased the maximum lenght to 5 inches it worked.

SOURCE: zebra lp2844 set up with paper with black

ihave 945 audio drivers . but no sound

Paulo Rangel

• 285 Answers
• Posted on Nov 13, 2010

SOURCE: my zebra printer wont line

run the sensor profile, check if check the gap, run manual calibration, if ask for reload media, please take 3 or 4 labels from the label rolar, put through the sensors (check if ribbon(if use) is install on the correct spots and don't stop the sensors to read the gaps) and run the manual calibration.

Paulo Rangel

• 285 Answers
• Posted on Nov 13, 2010

SOURCE: my printer says error condition paper out. But it

try to recalibrate media and sensors, run calibration, and run sensor profile, save, and restar again the printer. check if setings from the driver are correct or they can change the setings from the printer