Need wiring parts diagram for kenmore smartheat quiet pak 9 he4 gas dryer

You can check this site for parts, you will need o have skill, knowledge, and tools to repair dryer No one can tell what is wrong without inspecting item.
https://www.repairclinic.com/PartDetail/High-Limit-Thermostat/W11050897/4533962

Check here

https://searchmanuals.net/search7/?keyword=%2Bowners+%2Bmanual&gclid=CjwKCAiA8OjjBRB4EiwAMZe6y5_84V3ek15m17m45ZjUS8CJGN8CDmLdMHFmDUai5BTqkctyGuc0KBoCV8sQAvD_BwE

Sounds like the belt that turns the drum could be broken. I'd check that first.

My Kenmore Elite dryer keeps beeping..just going through the end of cycle alarm-high,low,off...anyone have any suggestions?

PF - Power Failure - PF error code indicates a power failure during the dryer's cycle. Press and HOLD start to continue the cycle, or press off/pause to clear display.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Hi,
If you have a gas dryer.
The most common problem with a gas and no heat is the ignitor going bad...

Here is a tip that I wrote about that problem...

http://www.fixya.com/support/r4398592-gas_dryer_not_working_gas_dryer_not

If your dryer is electric..
There could be a number of different problems...
Check out this tip that I wrote about this problem...


http://www.fixya.com/support/r3866345-dryer_troubleshooting_electric_dryer_won

heatman101

m dryer did the same thing tonight and it was the door switch luckly i wiggled it and it came back on

possible front control bd ..be sure there is 220 volts to rear connection first

Error message E1 indicates the temperature thermistor has failed.

The suggestion from barnsleymick gave us some good direction in fixing our Kenmore SmartHeat Quiet Pak 9 HE 4. We discovered our vent pipe was clogged with a great deal of lent and a quart or two of water. We cleared the vent of the lent and water and the dryer is now working like a champ! Thanks for the direction.