I have a error code U2-41 with my sharp MX 2300N and i cant enter in SIM MODE how i can solve this problems
The U2 errors are usually related to memory or board level issues. You should try to disconnect the fax and network and then kill the main power inside the cover. Turn the main power on and then when you get a solid green light on the control panel press that power switch. If the machine boots with everything disconected then try conecting the options one at a time and try rebooting each time to see if you can narrow down the problem.
I’m happy to help further over the phone at https://www.6ya.com/expert/ethan_e84416e0b13809d2
SOURCE: Sharp MX-2300N with error code H3-00. . how do I
Ensure you are in COPY mode
press # * C * ( one after the other, fairly quickly)
when the screen changes enter the number 14 on the keypad
press the B&W start button
press 1 for Yes when the question displays
press thw CA button
machine will re-boot and fault should clear. If it doesnt you need a service engineer. This is a fuser temperature fault
SOURCE: error code h5-01
Yes H5-01 is when it jams in the fuser 5 times in a row, check the fuser section for a jam, the paper jams up in there and does't trigger any sensors, once you have confirmed that its clear reset with sim code 14
SOURCE: sharp mx-2300N printer error maintenance required
VK means black developer has reached end of life. You can safly carry on using the copier with this message displayed but over time the copy quality may slowly degrade. You will need to call a Sharp authorized dealer to replace the developer in the developer unit.
SOURCE: how do you select an
To set an IP address, go to the system settings page. Enter admin mode (password if unchanged should be "admin") on page 2 select network settings and then ip address settings. Input your required info and switch machine off and back on when instructed.
I hope this is the info you needed.
Good Luck
SOURCE: network printing from a mac computer to sharp mx 2300n printer
Here's a new solution that works. When adding the printer, choose "Generic PCL Printer". This will allow you to print from your Mac to the Sharp Printer without buying the PostScript chip/kit for the printer.
4,973 views
Usually answered in minutes!
Hi when you say you can not enter the sim mode, can you explain why?
what machine is that if its sharp MX-2300N the enter sim and clean it by using sim 16.
to enter press copy mode on the touch screen the press P asterisk * C * asterisk.
if the problem persist the replace the controller board.
×