MY SAMSUNG TL 105 CAMERA LENS KEEPS GOING IN & OUT & DOESNT STOP UNLESS I PULL THE BATTERY

SOURCE: turn on camera the zoom

Hello

The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the probability is that you will have to get it fixed by a professional.

Use these at own risk as it may further damage the camera.

Firstly , try connecting your ac adapter or usb cable.

Try holding the shutter button while switching on the camera.

Look at the lens , and if some of the lens 'circles' is misaligned or not concentric then try wiggling it (while holding camera lens down).

Try gently pushing or pulling the lens when it extends but this is risky as it may cause the lens barrel to slip out of its guidance system.

Another way to do this is to place the camera lens down on a hard surface and then power it up. Be sure to use a soft cloth or something similar as to not scratch your lens or casing. Let the lens push the camera up and down a few times and sometimes the little resistance provided by the camera is enough to get things going again.

Try hitting your camera near the lens on the body with the soft tissue on the palm of your hand.

Other than that , I would take the camera to a repair centre for a evaluation to see if it would cost more to repair than to replace the camera.

If it is still under warranty I would suggest you take it in before trying any of these steps and remove any off-brand batteries or accessories as some stores are really fussy about warranty repairs on camera's with non-brand accessories.

You can also have a look at THIS link.

Hope the advise is useful. please do not hesitate to let me know if you need any further assistance. Also, please be so kind to let me know if you found this helpful.

Regards
Andrea

Testimonial: "At first nothing worked but after a few smacks not caring on what if ,the damn thing,came out and it still works great thank you joe."

SOURCE: Samsung TL 105, turns on, lens starts opening, lcd

Good day,

This tip will explain a few methods on how to try and fix your lens if it is stuck or you get a lens error on your screen.

Please note that all these methods are used at the users own risk and that I can not be held responsible for any damages or losses that occur while trying these methods.

1. If your camera is still under warranty, send your camera to the manufacturer to be replaced or fixed professionally.

2. If your camera is out of warranty try these methods.

• Make sure your batteries are fully charged.
• Remove the batteries for 10min. Replace the batteries and see if the problem persists.
• Try compressed air. This method can be useful if there are any sand or any other object stuck in the lens motors. Use compressed air with a fine tip. Direct the air between the camera body and lens and move in a circular motion around the lens to complete a full rotation.
• You can also try to tap the padded USB cover firmly on a flat surface like a table. This is sometimes a surprisingly effective method.
• The last method is to try and force the lens. Turn of your camera and place it on its back on a flat surface. Look at the spacing between the lens and the body and see if the gap is consistent all the way around the lens. If the gap is not even it is likely that the camera fell while the lens was extended. Now VERY GENTLY push down on the lens were the gap is the biggest until you her a "click". This will indicate that the lens is back in place. Try powering back on.
• If the lens does not extend or it extend and retracts turn of the camera. Hold the camera in your one hand and with the other hand turn the one part of the lens in a circular motion. Rotate both sections of the lens until you hear a "click". This will indicate that the lens popped back in place. Power the camera back on.
• The last method you can use is to turn the lens while powering on the camera until you hear a "click". Power the camera of and back on to see if it works.