The dbal2 bypass module will be wire to wire connection. have not made any connections yet.
The only 2 pin connector is for the transponder bypass module.
These wires are for the following outputs
2 Pin Transponder Output Harness #1123292
1) Red Battery (+) 100mA
2) Black (-) Output While Running 100mA
This connects your transponder key module to the starter, it activates the module when cranking to simulate a key.
a: When selected for while remote start on, the Black wire will be active at the same time ign. 3 becomes
active, and will remain active all the time the unit is operational under the control of the remote start.
b: When selected for output during the start sequence, the Black wire will be active at the same time Ign.
3 becomes active, and will remain active until the vehicle has started. This will be used for one time read
transponder circuits.
c: When the unit is selected for until ignition off, the Black wire will become active at the same time ign.
3 becomes active and will remain active even after the key take over and until the ignition in the vehicle is
turned off. This will allow the unit to be used for continuous read transponders circuits
SOURCE: prestige aps-57 remote start...car won't start
Hello hope this can help you. First check the starter wire, it is tan/lt blue located at the ignition harness. usualy during installation of the remote start system this wire is cut leaving you with two ends. one wire is coming from the ignition switch the other is going to the starter. the brain of the alarm hooks into both of these wires. if the repair man cut the wires from the brain and spliced them together he has just put the system back to OEM status leaving the alarm no way to engage the starter. I believe that may be where the problem lies but if not then I would say check your immobilizer bypass module the repair man mave have diconected that.
Thank you,
Luis
SOURCE: prestige platinum by audiovox need to replace the remote for it
if you need a remote you can buy one from audiovox.com and also you can download the installation manual and user manual in which that will tell you how to program the new remote for the remote start.
SOURCE: i need a wiring diagram for a car alarm .prestige
go to audiovox.com and u should find it there
SOURCE: cant remember how to use the remote
IT SHOULD HAVE iCONS ON THE REMOTE( LITTLE PICTURES OF LOCK AND UNLOCK THATS LOCK AND UNLOCK AND RTHE LITTKLE CAR PRESS TWICE IN TEN SEC AND THAT SHOULD START THE ENGINE IF ITS PROGRAMED TO ALLOW REMOTE STARTING AND RUNNING FOR SOME PRE DETERMINED LEGENTH OF TIME. GO TO THE WWW.AUDIOVOX.COM WEB SITE AND DOWNLOAD THE MANUALS YOU NEED... HAVE FUN HOPE IT HELPS...
409 views
Usually answered in minutes!
×