Try re-installing the battery driver.
SOURCE: I am charging the battery
The red light will turn blue when the battery fully charges - it is flashing because the battery is charging.
SOURCE: I CAN'T FIND MY BLUTOOTH
If your sure you have it -you will find the settings in-Control Panel-- go to START>CONTROL PANEL
SOURCE: I have a emachine e528 laptop when I cut my
First things first. Make sure you don't have anything connected in the USB sockets or the bays (CDs etc). Disconnect from the charger and also remove the battery. Hold down the 'on' button for 10 seconds...this will reset your laptop. Reconnect to power and try to switch on again. If the laptop still doesn't function it may be a RAM problem or a hard disc problem (you can try removing and re-installing both). It's worth trying a Windows installation disc to see if the laptop can boot from that. If it can, that will prove your RAM and motherboard is OK and indicate a problem with loading Windows. You don't say whether you get any 'splash' screen....that's the one that usually gives the manufacturers name briefly. If you don't even get that, it could be a bad omen. If you can get the Windows installation disc to boot, you can do a repair installation. To do that you go right through the installation procedure until you get the prompt asking you if you want a new installation or repair installation. This is different from the Repair Console- don't select that. You may find that the installation fails because the hard disc is no good. In that case you will have to transfer your data onto a new disc, there's free software to do that (you will need another laptop or PC)
SOURCE: emachines e528 touchpad not working
Hello try to renew the driver from here:
https://support.gateway.com/us/en/emac/product/default.aspx?modelId=3234
Please unzip the file before you install.
Try uninstall the old one first
Or the touchpad have a fault.
You can buy a wireless mouse if you have no luck with the driver.
Good luck
77 views
Usually answered in minutes!
×