All light on machine are on

Turn off the machine, unplug it and leave it off and unplugged for at leats 15 minutes. Try it again. If the machine comes up with flashing lights or an error code, something has failed in the machine.

If the machine still works, then it is just the light in the panel assembly that needs replacing (or the whole panel assembly itself). If the machine is also not working, try unplugging it and letting it stay unplugged for a few minutes, as much as 10. Then re-plug the machine and see it the lights come back on.

If cleaning the infuser doesn't work, sometimes the error will go away over time or after you try to unplug from the wall. Finally, a system reset may help: you accomplish a hard reset by having the machine plugged in, pressing and holding down both the decalcify and ground coffee buttons, unplug the machine for 15 seconds (still holding down the buttons), then replugging the machine into the socket before releasing the buttons.

Keurig reservoir light flashes when it is still at least half-full or more.

change door lock unit.. it sounds it has gone faulty.

All of the lights contiuously

All of the lights contiuously flash and will not brew. I have reset the machine, unplugged and re-plugged the machine,All of the lights contiuously flash and will not brew. I have reset the machine, unplugged and re-plugged the machine, dumped rinsed and refilled the water resivoir. Still nothing good and no coffee. I have since put the machine away and have stopped trying to use it. Any help that you might be able to give would be greatly appreciated. Thank you Tandie Grant

Unplug the machine for about fifteen minutes. When your fuse blown it caught in the middle of the cycle. By unpluging it will reset the machine.

Solution. Unplug the machine. Hold the power button for 10 seconds. Plug back in. Push the power button and the washer should turn on. Walk away leaving the machine on. When I did this, I came back to find the drum light off and machine would start on command now. Good luck.

would try changing the interlock unplug first regards jason

Insert a new 9 Volt battery (machine will work without a battery if you want to ignore the blinking light)