Question about Sony BRAVIA KDL-40V3000 Television

Dark outline of Programme information banner at top of Screen fails to clear except on rare occasions.

No attempt yet to rectify, but tempted to try using a lump hammer................

2 Suggested Answers

6ya staff

2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

jaymalsoni

2 Answers

SOURCE: Hi I have a sony bravia kdl-40v4000 tv and when I

try pressing the i+ key on your tv remote. that should get rid of this display on your screen...

Posted on Feb 22, 2011

Add Your Answer

Upload

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

Loading...

Include an image. It's worth a thousand words.

prev next

Related Questions:

2 Answers

Ni wave oven is making a loud noise when I turn it on.

Bearings or motor faulty!

Jan 29, 2017 | Microwave Ovens

1 Answer

I carnt tune ch78 into my Baurn flat screen

perhaps they have done something there that the channel has changed strenght and you will not get it . except on rare occasions .

Aug 28, 2015 | Televison & Video

1 Answer

Spots on the display screen

Still not clear, what you mean. But take care wham cleaning a lens. Never use a fluid like alcohol. Use a special lens pen or the soft brush on the other side of a lens pen, when you think the lens is dirty. Spots, or disk, also can appear when light is entering the lens from an angle. Even the expensive Fuji X10, had orbs or disks on the pictures in certain situations. Like dark with one or a few sharp lights close bye. Try the camera in different situations, to make sure the phenomena is in the camera or just a strange rare occasion.
When it is caused by a defect in the camera, it should show on every picture.

Dec 26, 2013 | Vtech Kidizoom Digital Camera

1 Answer

Programme Screen flashing in error

Sometimes cameras get "confused" if the battery is allowed to die and is replaced. Remove the batteries and wait 30 minutes for the camera to reset then put the batteries back in. This works on rare occasions and does not cost anything to try.

Hope that helps,
Bax

Aug 18, 2013 | Minolta Maxxum 300si 35mm SLR Camera

2 Answers

My windows 7 starter does not start only gives me a start up repair screen @ i got a linkid=104288

You could try to reinstall windows and see if that helps, but the hard drive is likely bad. There isn't anything to be done for a dead hard disk, so it would be best to back up the information on this one, attempt a reinstall, and then if that fails, get a new hard drive.

Nov 10, 2012 | Computers & Internet

1 Answer

The red triangle light, check engine light and VSC light are all on, plus the top 1/4 of the display screen is dark except for an outline of a car in the top left.

This just happened to my 08. What was wrong with yours?

May 03, 2011 | 2008 Toyota Prius

1 Answer

Cool but not get cold when tempt. set to 73 F. low pressure read at 80 Psi low blue guage. Clean replaced inside filter. Clean outside condensing unit, make clear of the area surrounding. On occasion...

i adviced that the copressor is loss compression that why it to loud when it is energized.. you must replace your compressor withe same part num and brand...

Aug 02, 2010 | Refrigerators

1 Answer

Hi I have a sony bravia kdl-40v4000 tv and when I hook it up to my pc or hdmi input the information banner stating "pc" or "hdmi" fails to disappear. This sits across the address bar on my internet page...

try pressing the i+ key on your tv remote. that should get rid of this display on your screen...

Jul 13, 2010 | Sony BRAVIA KDL-40V4000E 40 in. LCD TV

1 Answer

My range top is showing me E codes and I cannot get it to turn off

Range/Stove/Oven Fault Codes starting with an E

If an error code appears in the cook mode window
Your oven is equipped with an extremely reliable and accurate electronic control. On the rare occasion that something occurs that causes a malfunction, an error message will appear in the oven selector window.

Some errors (E1, E9, E11, E12, and E13) must be cleared by turning off the oven at the circuit breaker and then turning it back on. When an error remains displayed steadily in the off position, after attempting to clear the error, a service call is required.

Jan 26, 2010 | Kitchen Ranges

1 Answer

Warning lights

On a Prius, when the check engine light comes on it indicates a malfunction in the powertrain control system. You need to have the car scanned for codes to see where the fault lies. The red triangle lights because the check engine light is on. The VSC is disabled when the check engine light is on and that light comes on.
Start with having the car scanned.

May 14, 2009 | 2008 Toyota Prius