Kenmore Elite 45986 Front Load Washer Logo
Jackie Giacobbe Posted on Jul 06, 2009

Kenmore 'elite' HE3 front loading washer

I have the same smell problem with my Kenmore elite HE3. I noticed there is mildew along the grey rubber ring just inside the door and have wiped that off. We'll see if that helps. Also, I have found a few stray socks that have gotten stuck behind that grey ring--that probably didn't help the smell either. You might try checking to see if any have gotten lodged in yours.

When adding Borax or baking soda, do you just add it to the liquid detergent. Or do you use it IN PLACE OF your regular detergent??

Thanks and good luck!

2 Answers

randy

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Nov 13, 2017
randy
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Nov 13, 2017
Answers
2
Questions
1
Helped
1228
Points
6

Good old cheap hydrogen peroxide - best answer for mold. Wipe down the door gasket every week - no more mold.

Anonymous

Level 1:

An expert who has achieved level 1.

  • Contributor 1 Answer
  • Posted on Oct 06, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Joined: Oct 06, 2009
Answers
1
Questions
0
Helped
752
Points
1

I have the same problem. Nothing works fcfor the mildew. i have bleached it, used simple green and used baking soda. That washer is the biggest piece ever!! Good Luck!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4helpful
1answer

Kenmore Elite HE3 front loading washer, model 110.45872400 - completely drains and runs correctly but sometimes an hour later there will be water in the tub

Your water inlet valve is leaking it needs to be replaced.You need to remove the top to access it.There are screws along the back edge holding it on.
0helpful
1answer

Strong mildew smell in washer is making cloths & towels smell bad, how do you get rid of the problem?

if you look inside washer there is a rubber rim on the inside around the openning. Look inside and you will find where the stink is coming from. Keep door open when not in use and wipe inside of rubber trim to keep the mildew out.

I use tilex sometimes and do a rinse spin.
0helpful
1answer

Wet clothes after spin cycle and bad mildew smell. I have seen many complaints about mildew smell with He3 & He4 well really frnt loaders in general. The bad mold is so gross and the smell is horrible.

Clean tub boot the best you can with bleach. Then run an empty load with sunlight automatic dish soap (verry little). Then this should clean and freshin the washer up. The best thing to do is not to shut the door on washer when not in use.
0helpful
2answers

Mildew smell in Kenmore Elite HE3 (model 110.4586)

I found out that part of the water stays in washer that is why there is the mildew smell. Bad design.

John
0helpful
2answers

I have a Kenmore 'Elite' front loading washer that stinks

Have you been leaving the door cracked open after washing a load? If not, mildew will form and smell. If you have, then it would be something else. Respond with any questions.
0helpful
4answers

New Bosch water not draining

This video will show you how to change a door seal on this Bosch front loader washing machine
we have all bosch repairs in our channel
0helpful
1answer

Replacing the rubber gasket on Kenmore elite HE 3t

probably some rubberize installation are screw to the case or body/ you only need pollout are screw driver philips or flat .
1helpful
3answers

Mold & Smelly in Washer

Shepherd, Finkelman, Miller & Shah, LLC, is currently investigating defects and other problems in certain front-loading washing machines manufactured and/or sold by Whirlpool, Kenmore, and LG Electronics, including Kenmore Elite HE3 front load washers, Whirlpool Duet front load washers and LG Tromm, LG XL and other LG model front load washers, which result in the growth of mold/mildew in the machines and which can cause the staining of clothes and other problems.

On August 29, 2007, SFMS filed a Complaint against Sears Holding Corp. involving its Kenmore HE, HE2, HE3, HE4, HE5 and other front-loading automatic washers. If you own a front-loading washing machine that is manufactured by any of the above-mentioned companies and are experiencing the growth of mold/mildew in the machine, visit the following website: www.frontloadwasherclassaction.com
Not finding what you are looking for?

762 views

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Alexander

Level 2 Expert

171 Answers

Cindy Wells

Level 3 Expert

6688 Answers

vince

Level 3 Expert

2530 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...