My argox printer is not printing. only blank labels are rolling out and it doesnt want to stop. i have to poer off

Go to the Argox web site does your model printer do labels? check the media spec's. Are using the correct setting in the print driver? Check the printer setting on the machine. web site mite have a work around also might go to web site down load up grade driver to allow ding lables

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

It sounds to me like the label size is wrong, or more likely that the page size is wrong. Check the label settings. Make sure it doesn't have something like a separator page or maybe needs another label page behind it.

try driver from seagull scientific and choose printer model Argox X 1000 PPLB . double check with another parallel port cable.



gurjeet singh



delhi india

98180 14878

gurjeet99-at-gmail

Argox launched Ethernet industrial label printer
Adopted Ethernet management makes industrial printer strengthened
Argox adopted Ethernet into industrial printer series and launched X-2300E(203dpi) for regular resolution printing and X-3200E(300dpi) for high-resolution printing to meet different demands. Both X-2300E and X-3200E are equipped with enlarged memory - 8MB Flash Memory/16MB DRAM- leading ahead of competitors. The built-in RTC(real-time clock) is also an advantage to work alone with the printer to print time/date on the label without a PC.
X-2300E/X-3200E provides PPLA/PPLB/PPLZ(X-2300ZE, X-3200ZE) emulations for all application. And the auto calibration function supports 4 modes of setup provides flexibility for the users to choose the most convenient mode for different printing applications to ensure accurate label detection.
To satisfy the requirements of industrial printer application like wide area between operation systems in network and large number of equipment, utilizing Ethernet to deliver printing tasks is a more economical choice for enterprises. X-2300E/X-3200E installed Ethernet server to provide the interface of Ethernet data transfer and by using SNMP setup to deliver the error massage back to managing server to simplify the procedure and enhance efficiency.
X-2300E/X-3200E supports Windows 7 system and 1D barcode, 2D barcode, QRcode and etc. It's suitable for the production line of manufacture including safety labels, patent labels, and?parts-name stickers, and fit for the application of shelf-label printing management, storage, delivery, shipping, transportation, luggage labels and wash care labels for clothing.


LINK IS GIVEN BELOW..................

http://www.argox.com/content.php?sno=0000486

GOOD LUCK......................

Need Window 7 driver

Hello santiago271 ,
Hopefully problem might occur with the printer calibration setting, try printer calibration in argox printer,
if that does not work, check the label mm/inch setting.
if that do does not work, check the labels peel gap in between is even.
Hope fully, this should solve your problem
If you Any other queries, Related to barcode printer - Sales and Services.
Contact , Trridev Labelss Mfg Co Leading Labels Convertors In Tamil nadu
For more information visit our web page.

Hello !
This model is an thermal printer.
The thermal printhead need to be cleaned with isopropylic alchool with a cotton bud.

All the best !

possible prpblems

1. your design need ribbon but your ribbon not installed
2. your label label gab type set but your design set continous type label

3.may be your calibration fail. You can calibration with one key.

best regards

Ufuk

Your ribbon is not firm enough - roll the ribbon at the top until it is firm. If it is too loose it will stick to the paper. Follow directions to ensure that ribbon is installed properly.

We have found a reset that we use.
We unplug the printer and then we hold down the feed button and we keep holding down the feed button while we plug back in.
It goes through some sort of a reset and this sometimes works.