All of a sudden it just stop working right after a load that was perfect. Now when you pull the knob nothing happends

Rinse on most washers is cold water your wash cycles can be cold hot and even warm. Problem You may have is a bad water feed valve Or Timer and possible bad wire harness at motor to timer
check water valve Turn washer to regular wash cycle pull knob on will washer fill ?
if water starts to fill then change washer temp if washer has this.
if water comes out on all settings water valve is fine.
Check the water both hot and cold that it is turned on;at faucet.
Your Kenmore Most likely has a bad water valve check for hot water side clog or not working.

Check the Transmission Cable. It could be half torn Transmission cable. You may have to replace the cable then

hello any spin problems can be caused by the module control board usually sits at the back of the washer may have a load of wires coming off it hope it helps

regards
shaun

Push down on lid or lid switch.

THe same thing happend to me just now grrr......
I'm really not a technology expert or anything but, when I looked inside of the the "button" I saw a small scratch on the green and gold plate. Did you perhaps notice anything like this? I'll probably have to replace it or something........

But seriously, I hope this problem is solved soon.......

you will need to replace the spark module inside the unit

The control board went bad. Your switch went bad or you blew the fuse. All are located behind the knobs. Just remove the knobs and undue the screws up top. Make sure to unplug the system before opening it up

Check your fuses.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

It sounds like the water solenoid has gone bad or stuck closed OR timer/control knob has bad set of contacts which control the solenoid.

sounds like motor if nothing stuck between tubs or in pump ,check these first if ok you have bad timer