Digital seconds two ahead of analogue. How can I synchronise please?

Hi, did you find a solution? I have the same problem with this beautiful, but stupid watch.

Page 4 of the Omega manual at this link describes how to synchronise the digital and analogue displays http://www.old-omegas.com/1665en.html - works the same for Tag.

This usually occurs when the battery is changed. There should be a process for synchronising the two times detailed in the manual.

To get a manual you go to "http://tissot.ch/" and on the black menu bar at the bottom of the page you will see "product support". Click on this and you will go to a page of instructions. Download yours and find the relevant method for putting your watch right.

Click on my profile (escapement), then click on Tips and Tricks. There you will find link to all Casiowatch manuals.Rate me, please.

Hi!

press the lower left button until "H-S ET" appears, then press upper left button for 3 seconds ("-0 0-" appears on the screen), press lower right button for adjust the seconds hand

Check out if your watch has two separate batteries - one for digital and another for analogue movement.
If it does, replace analogue battery. If it does not - you will need help of a watchmaker.

Rate, please.

Try rotating the analogue hand 12 hours ahead of the current time

Follow this link:

http://world.casio.com/wat/download/en/manual/

Rate, please.

hi...

press the T button until the crystal is activated.
press the middle of the glass until the time format appears (24hb Cm appears)
hold the T button for 5secs (SYNCHro appears)
move the hands until they are at 12 o'clock. ( + button moves the minute hand. - button moves the hour hand)
press the T button to set.

digital and analogue time are synchronised

pol

It is possible to set the main analogue hour and minute hand 30 minutes out of phase with the digital readout, but doing so will also put the analogue UTC dial 30 minutes off. It can be done by using a variation of the proceedure for zeroing the watch hands as follows: 1. Rotate the crown in its normal opering position to set the watch in chronograph mode (mode dial pointing to "chr") 2. Pull out the crown to the second click. This should cause all the hands on the watch to return to zero. "HR" should appear on the left-hand digital display. This will allow you to move the hour hand by twisting the crown. Advance it to about half way between the 12 o'clock and 1 o'clock positions. 3. Press the top button. "MIN" should appear in the left-hand digital display. This allows you to adjust the minute hand. Twist the crown to advance it to the 6 o'clock, or 30 minute, position. Note that this will also move the minute hand on the small UTC dial to the 30 minute position. 4. Press the crown back into its normal position. 5. Reset the digital time and date according to a time zone that is in a one-hour offset from UTC. This is not a perfect solution. Your digital readings will show the correct time for all one-hour offset time zones while your analogue nads are 30 minutes out of phase. Your small UTC dial will also be 30 minutes out of phase with the digital UTC. Hope this helps.