Hi , says needs service 105 .normally power off at wall and it comes right . this time jus beeping and not reseting.please help.

Samsung ER 4940 cash register

left off the ER in the model?
a cash resister, posted to computers forum.
ok.
seems it needs service, ask samsung first for help.
?
off hand. I'd say bad keys.? or stuck?
power it off, , the with power cord unplugged from wall AC
for say 15min, or so. the line cord back to AC jack in wall.
power on with key lock in REG position, and hope for a reset?

power outages cause power surges when the power comes back on
this surge generally manages to fry the power/control board
I suggest that you get the services of the service centre to come out and check it out.

i forgot my unlock code for nokia 105 my IMEI 357286/05/457170/2 please help

After reset? With reset dealer tools procedure? Or jus disconnecting battery?

You will need using the dealer tools in order to reseting and setting new periodical time maintenace.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Hi, the faults 105 is reported when the Display Module detects an error in the communications between the Display Module and the Motor Control Module.

The primary source of the problem is the Pump and you have to measure resistance of pump. If resistance is less than 33 ohms, replace pump.

Hi, what you need to do is reset the display back to standard. Please follow these steps to do this :

Step 1. Turn the PS3 off into standby (red light on)

Step 2. Press and hold the power button. It will beep when you first press it, then beep again 5 seconds later. Release the power button when you hear this second beep.

Step 3. Wait for the PS3 display to reset

Hope this helps and thank you for using FixYa

Please follow the below troubleshooting steps: 1. If the Television is plugged into a surge protector, remove it from the surge protector and plug it directly into the wall outlet. 2. Try connecting the TV to a different AC wall outlet. 3. Try power resetting the TV. To Reset the TV, disconnect the power cord for a short period of time (approximately 1 minute), then reconnect the power cord and power ON the TV. 4. If the issue still persists, TV will require service.

is it as 44c or a 44j?
thanks,
Lee

Hi,

You can fix it by doing this. but first you need to make sure you leave your house for at least 4 hours so you don't have to be hearing that frigging noise, IT CAN BE DONE! i fixed it.
my unit would start beeping as soon as I plug it in wall, and red light come on, the software is telling me the battery is unplugged
this is what i did in order.
1. unplug all cords, connected to the unit, and power cord to the wall.
2. hold the power button
3. still holding the power button, Connect it to wall. (red light would be on but no beep)
4. I watched TV for 6 hours, red light still flashing
5. disconnect from wall
6 connect back to wall

I heard the unit click one time and green light came on, is charging now....

• please go to LG service centre rather than going to local repair centre.
• as i think that they give first service at some concession rate.
• i do not think it is much.
• as no part in tv is that  costly
•  except crt which is rarely fails in two years time.
• please call them they will come to your home and will do that.
• it is not major problem.
• hope this will help
• good luck.