Security Camera ok, this is how it is power supply wire colors 3 sets of wires 2 coming out on each plastic tube thing. white bar wire (ground) yellow bare wire (ground) Red bear wire (ground) Now the camera wires Grey Orange Brown Green Yellow Red I need to match the power wires to the camera wires. I know this is complicated but it's the only way I can explain it. The power supply wire colors needs to be connected to the camera wires. I don't know which wires go to what.

Here is a color diagram of the distributor plug for a 1997 Nissan Sentra GA16DE:
Pin 1: Black/White wire - Ignition pulse signal Pin 2: Green/Red wire - Ignition coil power Pin 3: Black/Yellow wire - Ground Pin 4: Blue/Yellow wire - Engine speed sensor signal Pin 5: Yellow wire - Power supply Pin 6: Green/White wire - Ignition coil signal Pin 7: Red wire - Power supply
Please note that wire colors may vary depending on the specific vehicle and wiring harness. It's always recommended to double-check with a wiring diagram or a professional mechanic before making any electrical connections.

You have video audio power and ground

red & black is your power + & ground -. Yellow and black is your video and ground. you probably don't have audio if there is not another wire. If you have a shield wire around the others sometimes that is used for ground and in that case red and shield wire would usually be the power.

use 3+1 wire in that wire there is one co-axial cable middle one is video , outer one is ground , red is +12 v and blue connect to ground
camera----------------yellow-----video------------middle wire of 3+1 cable
camera----------------blue---------voltage----------- 12v dc +
camera----------------black--------ground------------ground of supply

camera----------------

I have yellow blue red and black how to hook those up?

The RED wire is your 12 volt power "positive". The BLACK wire is your 12 volt power "negitive" The YELLOW wire is your camera video. The white wire is your cameras audio & the copper wire is shielded ground.{Davesajak}

I have a small color security camera with infrared that is intact. This camera is an exclusive Harbor Freight Tools distributed product. I have attached pics of it, the last pic of the small connecting box looking into the connection starting from left to right are 4 wires 1=yellow 2=blue 3=orange 4=white. I hope this is of some help to you. I unfortunately don't have the other end of the connector and am looking for pinouts to hard wire it to my monitor. If some one has this info please pass it on to my email zimpmd at aol. Thank You Michael Zimpleman

The red and black wires if ran correctly are the load lines(power). The white is neutral or ground. If its a 1/2 to1-1/2 hp motor connect the red and black wires to terminals #1 and #4. If its 2 hp use #1 and #4. If its 3 hp use #2 and #4. Connect the white wire to the green colored screw. A grounding conductor should always be connected under the green grounding screw, which is located within the terminal compartment of the motor. You can check the breaker for the wire colors, one should be black and the other red. The white wire should be terminated to the neutral/ground bar in the can.

I HAVE A SECURITY CAMERA GOT WITH THE WIRES RIPD FROM BACK OF IT 4 WITH WIRES 1 RED 1 WHITE 1 YELLOW AND 1 THICK BLACK WIRE HOW CAN I REWIRE IT?????