No picture or sound , green led in front stays on for 10 sec. then went out as one red flash comes on . The process repeat itself. Upon removing the back cover ,an orange led was observed to flash 3times followed by the green led in the front going out as the red led in the front flashes once. The cycle repeats with the green led on and the orange led on the FB1 BOARD starts its flash count .

Power Board Problem

Hi
You have to check how may time that led flashes. check the link for more details about led blinking in sony bravia tv.

www.electro-medical.blogspot.com

My Loewe did the same thing tonight. The picture went blank and the rered and green light came on together. Any suggestions?

One of two things can be the problem...one the bulb is bad...two the ballast is bad. If the bulb is not bad then the ballast is...it can usually be fixed by replacing a resistor on the board itself...it is labeled R3 and is a 1000 ohm resistor

http://www.sonya20tvclassaction.com/main/home.sfx MAKE SONY FIX IT

Thats the great sound of Exploding capacitors on either the power supply board. or another one in there. Now the set is in fault protection. It tried to warn you with the RED blinking LED that there was something amiss by shutting itself down. When you unplugged you reset the error and allowed it to do it again.

Best Regards and Smper Fi

or a new lamp. you could first replace the lamp.
the screen might work fine for a couple of seconds, but then it fades away or deteriorates. This means the lamp is going bad.

yes ill got remote link for u here give me one sec

You can try this on the remote in standby mode, meaning tv plugged in but set off. Press Display,5,vol+,power on remote.Press each button within a 1 sec interv. Next the CRT display the item being adjusted. Press 1or4 on remote to select item. 3or6 to change the data. Press Muting then Enter to write into memory. Service Reset muting green enter red. Press 8 then enter on remote to initialize. turn set off to exit. wait least 10 sec. before turning back on.

Yeppers. Sounds like the standby power supply has a bad capacitor in it and the regulator Ic is defective. These parts should only be replaced by quilified technician as there is very high voltage inside these sets. Good Luck