Moving the treadclimber the wires broke, does it matter which way the wires connect or do i need to buy a new one and where to i buy it?

Hi,
yes you can do it. But only thing you have to remember is when ever you do it please remove the power from the ac out let. after making connection or disconnection just put back the power cable to ac outlet. keep the connection well insulated if you are going to make it as permanent. do not touch it while the treadmill is powered.

www.electro-medical.blogspot.com

The motor was damaged and needs to be replaced. Any and all moving parts under water can sustain damage to include rollers, guides, thrusters, metal gears, and other associated parts. Claim with the insurabce company if insured.

Put new one if not catalytic con. will be next.Could cost $500.00+

adjust the reed switch, see the diagram clean it, tight the plug very well.
God bless you

if the crank shaft turns and the piston doesn't the connecting rod that connects them broke make sure that the journal the rod rides on isn't scored before buying a new connecting rod

A three wire connection dryer cord hookup. Notice that there is a ground strap connected from the common center terminal to the frame of the terminal block. Place the center wire of the cord on the center terminal [ one with the ground ******** it ] and the other two wires will be placed on the outer terminals and it doesn't matter which wire goes right or left. Get the center wire of the cord right and you are in business.
A 4 wire dryer cord hookup. Notice that the ground strap has been removed from the terminal block frame and folded back onto the center terminal for storage. You can see the colors of the other hookups. TIP: White always to the middle.

Here is a link to a very informative site
http://www.applianceaid.com/general.html#3to4

call an exorcist

Check the wire connection at the bottom of the right upright. Male Female white connectors. if they are good then check speed sensor under the left rear treadle. Must be about credit card distance from drive pulley. Remove rear covers to access. Note you will have to remove both side covers and back cover. 10 Screws.

Yes. Contact Bowflex directly and speak to a customer service rep. They will assist you with part # and prices. If you need part schematics ask them to send via e-mail. Put in a file so you will have them in the future.

You will need to make contact with bowflex if you broke the item. You may be able to glue back the item as well. The front lid come off, sometime you have to tilt the machine with another person. This will allow you to get to the under side.

I’m happy to help further over the phone at https://www.6ya.com/expert/howard_079189dd4959a511