Why is the machine tearing an not filling the tubes?

Mystery machines are always problematical to answer. We ask for full 'make model (what it is)', and a clear question.

Do you mean the drain hose? The only other tube is the one to the water level sensor.

Drain hose issues are normally caused by pump obstructions.

Water level sensors can fail, but you need to make sure the seal on both ends of the pipe are airtight.

If faucet is full opne, probebly are clogged filters Remove inle tubes and in the connection of tubes with machine youll find those filers. Remove them carfiully, wash them, reinsert and screw the tubes back.




How To Clean Your Washing Machine Filter

This is some what normal.

One common error with these machines Is that the water level sensor pipework has a small hole. The pipe is connected to the drum, and as the unit rotates it will cause the rubber tubing to be degraded. If a small tear appears it will cause the sensor to malfunction - when there is no negative pressure as the water drains (or vacuum) it assumes the water is still there/. Either find the tear and repair with bicyle repair kit, or if the tear is near to the sensor connector - cut off and reattach slightly shorter tube.

take the two rubber pieces out of the corner of the top

Did you check your bellows for tears.That is the rubber that attaches tub to front of washer. the part that the door closes on. check in and around for tears in it ...Good luck if i helped you please vote ..thank you

with so few parts for this washer I think your board assembly went bad. You can find this part at www.repairclinic.com/SSPartDetail.aspx?s=t-WPRE6100G-%3d%3di1472727&partID=1472727 That is the only thing I can think of.

thas exactly correctits amotor coupling part number 285753A, probalby $25 and you can find complete tear down of unt on you tube

check the tube leading away from the fill level switch for splits .take tube offr and check for blockage. this tube goes to the air chamber which may also be clogged. if so clean it thoroughly

Had this problem. In my case the leak was comming from the fill indicator tube. It is a small tube running from the side of the tub to the control panel. Air pressure built up in this tube activates a pressure sensor that will shut off the fill valve at different levels depending on the pressure. The tube had become dry and cracked at the joint where it met the tub. I didn't discover the source of the problem unitl the hose actually tore loose and the thing overflowed. Remove this tube and inspect it and I bet you will find a small crack or tear.