Reset this switch. password not available anymore.no pinhole for reset button. how to???

depending on the model of the router, it will have a tiny pinhole reset button. you will need a pin to reset. hold for 5 sec. The router will reset itself. This will reset the password as well as the settings

There is usually a factory reset button located in a pinhole on the back where the connections are. Turn the router on and press the reset button for 5-10 seconds. This will clear all the settings including your password. You can find the factory password in the manual or online.

If you have forgotten your password you can reset by hitting the reset switch on your router. This is a pinhole on the back of the router near the power cord. Use a pen or pencil to push the button at the bottom of the pinhole to reset the router.

look for a small pinhole that is reset switch power up insert paper clip 5 seconds should reset all passwords

look for pinhole that is reset switch hold in 5 seconds should reset all passwords

There is a pin sized reset button hole on the back of the unit. Press and hold the reset button for 10 full seconds. Then wait a few minutes and it should all be reset to where you can use the default username and password. That is usually admin for both or admin and password.

There is a little pinhole button that resets the router to the factory defaults. On some routers it is on the "back" somewhere near the switch ports, on others it is discretely placed on the bottom in a corner, and on others still it is on the front.

If you meant switching from DSL to CABLE, I would suggest just giving your router a reset. Here are the procedures for your particular router:
Reset Procedure
Step 1 Locate the reset pinhole on the back of the unit.

Step 2 With the unit powered on, press and hold the Reset button.

Step 3 Hold the Reset button for about 10 seconds.

Step 4 Release the Reset button.

Step 5 The unit will reboot. Allow 20-30 seconds before reconnecting.

Step 6 The device is now at factory defaults.
make sure to setup your wireless security again and make sure to set an admin password on your router after the restart.

Nope like all wireless router it should have a reset button or a pinhole near the ports.Use a paper clip to reset. This will return the router to default and you can set it up a again for your network.
Good luck

How do I use the reset the password on my DES-3226?