I have a estudio 255 copy machine .i updated the new firmwere locally . now printing function is not working

U need to make sure printer kit is installed, follow by networking settings on MFP and printer driver on PC in order to print.

U have to purchase printer and scanner kit

you must connect the machine with you're computer.you want the fax you must check the you're photocopy machine have a fax board.you want the scan & printing connect the photocopy machine to the computer.(network cable)

Did u insert genuine toner, because there is a chip on the toner...

It cannot be done without the dongle.
But u can try the trial period, once the trial period is almost reach, u can try update the machine firmware. But not sure whether it can work or not...

just clean the right area glass ( the width narrow rectangular glass area ) at the right top glass.

the toshiba e350 needs a print dongle if the dongle is in

try this
1. turn on the power while 0 button and 8 button are pressed simultaneously
2. key in 947 and press the start button
3 press the initialize button
resart the machine

if it does not work then you can try updating the firmware and if that does not work then the card may be faulty

have you tried firmware update on the bypass you have a green lever make sure its in the up position so that the tray does not lift and try reloading driver or reload your windows

You have to have the USB stick to enable the scan.
It locates on the right side near the back of the machine.
They make , print dongles, Scan dongles and print scan dongles. But that USB device enables scan.