Machine does not go through the cycles correctly

Replacing the wash cycle selector knob on an Ariston AV 105 washing machine can be done with the following steps:

1. Turn off the washing machine and unplug it from the power source.
2. Locate the wash cycle selector knob on the control panel of the washing machine.
3. Remove the old wash cycle selector knob by pulling it straight off the control panel.
4. Inspect the knob shaft to ensure that it is not damaged or worn. If the shaft is damaged, it may need to be replaced before installing the new knob.
5. Align the new wash cycle selector knob onto the knob shaft, ensuring that it is fully seated.
6. Push the new knob firmly onto the knob shaft until it clicks into place.
7. Test the new wash cycle selector knob by turning it to different wash cycle settings to ensure that it is functioning correctly.
8. Once you are satisfied that the new knob is working properly, plug the washing machine back into the power source and turn it on.

If you do not have a replacement knob, you can contact Ariston or a local appliance parts supplier to obtain the correct part. Make sure to have the model number and serial number of your washing machine on hand when ordering a replacement knob to ensure that you receive the correct part.

alot of newer machines do that. water saving feature

Most machines will reset if you press the stop button or otherwise end the cycle. If all else fails, un-plug the machine, wait a few minutes and plug it in. Otherwise, just let the Self Clean cycle finish.

Ice makers defrost is the harvest cycle. The purpose of a defrost cycle is to clear any ice build up, right?

Hi Tina just read your posting. From the information in your posting the machine fills, then when the machine is full of water the agitator moves clockwise then anticlockwise until it gets to the rinse cycle then drains the water ,then it fills for the rinse cycle but does not move the agitator in the rinse cycle.Then it drains and spins the clothes dry .Is this assessment of your posting correct.If it is not 100% correct please reply to tell me what the machine is doing or not doing.If it is correct then the problem with your machine is the control board.Is your model the electronic one with the push buttons?Looking forward to your reply.

Make sure that the top of the waste water pipe is at the correct height for the machine, typically around 30-34 inches from the floor (see your installation instructions). If it is any lower then it will start a siphoning action as soon as the water reaches the same level in the machine and never actually fill up and hence the cycle will not start. If the machine detects that insufficient water has entered the machine within a given time, typically 8 minutes, then if flags an error to the on board controller. If the error persists after the waste pipe height is corrected then check out the pressure switch for correct operation as if this is not triggered then the cycle will also not start or will halt almost immediately.

Check the door switch, if it's faulty the spin cycle will not work, but everything else will.

code 00 means machine did not spin

check load for out of balance

redistribute load and restart

good luck