Why does my asko washer W622 display keep circling?

Get them transferred to DVD.

https://www.google.com/search?q=w622

'make model (what it is)' in all questions please.

..

It's goosed

Yes commonly this problem is only in the setting or format of the video you are using, try to check in the lcd of your vcr if there is a PAL or NTSC, then try to change the format.

i have an asko3132 washer starts but no water coming into washer then stops and displays error F7 have cleaned filter do i reset if so how

if the valve was stuck open it would run all the time the washer was on i would say that there is a power short running to the valve turning it on when not selected

sonic boom electronics australia

This is caused by the "anti flood" system being activated. Consists of a polystireen float and micro switch at the base of the washer. Once water leaks / spills are detected it activates and puts the washer in pump out mode only. You need to dry the base / check for leaks / rectify leaks (normaly a small hole in pipe or pipe clamp).

hold down the "cycle signal" button for 3-5 sec. unplug and plug back in. should clear and reset computer

The exterior size hasn't changed and the plug to run the washer is the same so I don't see a problem. A good retailer can check this for you , but I haven't seen any difference in the stacking kits.

check the fuse on the back panel if thats ok check to see where theres power it may be a display board fault.