I need a lid for bruan 4243. the bit that goes inside to enable turn on, has broken off. Peta

Peta.com redirects to Peta.org which is the actual domain name to the animal rights organization based in Norfolk, VA.

For more information on PETA (People for the Ethical Treatment of Animals) refer to this Wikipedia page

If you haven't used it in a while or if it is in a cold area, it may be a warmup issue, try turning it on a waiting a few seconds, even in the best time there is a delay. You are correct to expect the bulb to last a long time most Ott bulbs do last!

See ebay if you haven't got this already I am just listing one and lid. Ok its states for a 4243 but they are interchangble I have found

Make sure battery cover is on correct then call customer service @ bruan

Did you ever get a lid? I am posting one on ebay now for a 4243 they are interchable to my knowledge.

You may have had a foriegn object fall inside the printer such as a pen or paper clip.You may also have a broken sensor which enables the carraige to move to the centre when the lid is open. You can try and carefully move the carraige over manually when the printer is turned off to see if there is something blocking its path. If the sensor is broken you can replace the cartridges by moving the carraige over when turned off.

Tarvitsisin osan braun type:4243 monitoimikoneeseen.
osaan kiinnitetään erilaiset raastin ja viipalointiterät - mistä saisi ostaa??


[email protected]

Sure there is, take a look on amazon. here: HOOK UP Connect Customize Entertain I hope this was helpful. cheers

I had the same problem and first checked the instructions in the Epson manual on the red flashing problem, read the following pdfs: Indicator light or problems

I saw the fluorescent lamp come on for a second before the indicator light started to flash red, so I knew that the lamp was ok and did not need to be replaced. Try this turn off the scanner and try unplugging the transparency lid from the back of the scanner, turn on the scanner and see if the light goes back to green. My issue turned out the be the mechanism inside the transparency lid, I kind of heard an awkward noise when I turned on the scanner, but thought it was coming from the base, I rlocked and unlocked the transportaion lock on both the base and lid, to see if that would fix it but it turned out it was coming from the lid, where there is also moving parts inside using a belt and wheels. On the end wheel closest to the front, the 2 little plastic pegs that hold down the square metal plate with wheel broke off, I could hear them inside when I lightly shook the lid, anyways I opened up the lid by removing the 5 screws and you need a screwdriver to put in each of the little openings around the edge to pry open the lid. I removed the belt and metal plate, watch out there is a spring attached to it, don;t forget how this part works when you put it back on, I found both of the little broken pegs and glued them back on with a strong plastic epoxy glue that I bought at Ace Hardware, I let that dry for 24 hours and then put the metal plate and wheel on then put the belt around the wheel, and now everything works fine.

Repairclinic.com had the parts I needed (crisper drawer lid and the longer drawer lid.